User manual AKG TM 40

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] If anything is missing, please contact your AKG dealer. You can replace the color code battery cover with the supplied black replacement cover. M: The signal delivered by the microphone is muted while power and the RF carrier frequency remain on. This prevents the receiver from responding to interference from other transmitters. The color of the battery compartment cover indicates the carrier frequency of your transmitter module: 9 The color of the battery cover indicates the carrier frequency of your transmitter. M: The signal delivered by the microphone is muted while power and the RF carrier frequency remain on. This prevents the receiver from responding to interference from other transmitters. The color of the battery compartment cover indicates the carrier frequency of your transmitter module: See Manual Supplement LED lights constantly: battery will be dead in about 60 minutes. 4 Input Gain: This rotary pot sets the sensitivity of the transmitter module's audio section. 5 Charging contacts for charging a rechargeable battery inside the battery compartment using the optional CU 40 charger. Pull the battery compartment lid (1) down to remove it from the transmitter module. If you do, the battery will not be held in place properly and may cause a rattling noise. If there is a dead or defective battery inside the battery compartment, remove the battery. Insert the supplied or new battery (2) into the battery compartment as shown in fig. If the status LED (4) lights constantly the battery will be dead within about 60 minutes. Replace the battery with a new one as soon as possible. Slide the battery compartment lid (1) onto the transmitter module against the direction of the arrow to the point that the lid (1) will click shut. 3: Instead of dry batteries, you can also use a 1. [. . . ] 5-V AAA size battery >11 hours (dry battery) >6 hours (rechargeable battery) 300 mV/1 kHz length: 125 mm (5 in. This product complies with the following standards: EN 300422-2 V1. Specifications subject to change without notice. [. . . ]