User manual AL-KO LHS5500

[. . . ] Garden + Hobby QUALITY FOR LIFE D F NL H CZ RUS FIN N SLO GB I E PL SK S DK RO HR Information I Manuals I service holzspalter lhs 5500 / lhs 6000 / lhs 7000 Betriebsanleitung 462 707_e I 02/2010 © Copyright 2010 AL-KO KOBER GROUP Kötz, Germany This documentation or excerpts therefrom may not be reproduced or disclosed to third parties without the express permission of the AL-KO KOBER GROUP. D5 Original-Betriebsanleitung Log splitter Safety instructions Read the operating manual and adhere to the instructions therein at all times. Retain the manual for later use and pass on to the future owner in the case of resale of the unit. Observe all safety and warning instructions on the unit. [. . . ] Inform the dealer if deficiencies are detected. Note: Tools required for assembly are depicted in Illus. These are not included in the scope of delivery. Note: Check the direction of rotation of the motor in the case of a log splitter with a three-phase current motor (LHS 7000). The direction of rotation should correspond to the arrow on the fan cover. A polarity reversal should be realised in the plug with the phase inverter if this is not the case. Press in the phase inverter in the plug with a straight screwdriver and turn through 90° (see Illus. Establish the power supply and check the direction of rotation of the motor again. Grease the control arm bearing position top and bottom (Illus. Insert the control arm and tube in the transverse connection recess (Illus. Insert the retaining pin from above past the tube to the left and secure below with the washer and split pin (Illus. The log splitter should not be operated if components (e. The protective hoops) are missing or defective or the connection cable is damaged. Adjusting the retaining claws The retaining claws can be adjusted to suit the diameter of the timber. They should be set to the same dimension on both sides. Loosen the star grip on the retaining claw and adjust longitudinally to suit the timber diameter (Illus. The log splitter should not be operated if components are missing, defective or loose. With cracks, cuts, crushing damage or bends in the insulation) should not be used. Visually inspect the hydraulic components for leaks. Mount the splitting cross and screw the fixing screw into the recess in the splitting blade to draw the splitting cross upwards completely. Secure in the end position with the locking nut (Illus. The log splitter should only be used by one person. [. . . ] The splitting column should be lubricated with grease free of resin or acid before every use. This increases the service life of the sliding jaws. maintenance work Sharpening the splitting wedge 1. The splitting wedge should be sharpened with a suitable file if necessary. [. . . ]