User manual ALCATEL SPEED TOUCH USB

[. . . ] Speed Touch USB Installation and User's Guide 3EC 36714 AAAA TCZZA Ed. 02 Status Change Note Released BD F aa 39808 Short Title CD-UG STUSB PPP All rights reserved. Passing on and copying of this document, use and communication of its contents not permitted without written authorization from Alcatel. 2 / 48 3EC 36714 AAAA TCZZA Ed. 02 Contents Contents 1 Get Acquainted to the Speed Touch USB . [. . . ] On your desktop the CD rom icon will appear: 3. Double click the CD rom icon to proceed. The CD rom contents window pops up: Double click 4. to open the Mac OS10. x installation folder. to start the In the Mac OS10. x folder, double click installation. 3EC 36714 AAAA TCZZA Ed. 02 29 / 48 3 Speed Touch USB for MAC OS 5. In case an Administrator password was set, you must provide it before the Installer is able to continue with the STUSB installation: 6. 7. Provide Name and Password or Phrase and click to proceed. A Welcome and Readme screen subsequently pops up. time The Alcatel Software License Agreement screen pops up: You must agree to it before you are able to continue. The following screen allows you to select a destination volume to install the STUSB: Select a destination. Your selection will be highlighted by a green arrow: 9. Click to proceed. The Installer has now all information to continue with the installation. Click to start the installation. 30 / 48 3EC 36714 AAAA TCZZA Ed. 02 3 Speed Touch USB for MAC OS 10. At the end of the installation procedure, the following screen appears: Click to finish the installer. STUSB hardware installation 1. Plug the ADSL cable, provided in your package, into the inline receptacle of the STUSB. Plug the other end of the ADSL cable into the wall socket terminating ADSL service. 2. Note: Depending onto which pins of the wall socket the ADSL signals are assigned, it might be necessary to plug in an RJ11 interchanger into the wall socket prior to connect the ADSL cable. Plug the STUSB's USB connector into the computer's USB port. An USB port can be easily located, it is marked with the typical USB symbol: 3EC 36714 AAAA TCZZA Ed. 02 31 / 48 3 Speed Touch USB for MAC OS Installation results After you have correctly followed the STUSB installation procedure, the following applications and icons are added to your system: " SpeedTouch USB added in network list: In the Network panel, the Alcatel SpeedTouch USB is added in the list of available network devices. " Dock SpeedTouch USB status icon: An STUSB status icon is added to the Dock, allowing instant status information of the STUSB. " SpeedTouch USB Diagnostics application: A STUSB Diagnostics icon is added to the applications folder. Additional configuration Next to the installation of the STUSB software, your must configure it for Internet connectivity. Open your System Preferences and click panel. Select the STUSB from the list of available network devices: to open the network 3. The first tab 'TCP/IP' of the Network panel shows the TCP/IP settings for the STUSB network connection: Check that the connection is configured for PPP connectivity: 32 / 48 3EC 36714 AAAA TCZZA Ed. 02 3 Speed Touch USB for MAC OS 4. Click the 'PPP' tab. [. . . ] 02 47 / 48 AppendixB Safety and Agency Regulatory Notices B. 2 Safety and Compliancy Statements This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against such interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. [. . . ]