User manual ALCATEL T60

[. . . ] Call your local phone company to have one installed. Wall plate SETTING DATE/TIME Modular telephone line jack OR OR INSTALLATION CAUTION: Disconnect the phone cord from the wall outlet before installing or replacing the batteries. Never install telephone wiring during a lightning storm. [. . . ] Insert 3 AA-size alkaline batteries (not included) as shown on the engraving in the battery compartment. Snap the battery compartment door back into place. Reconnect the telephone line cord to the base. Enter your long distance code MAIN FEATURES FSK/DTMF auto detect. Record up to 58 incoming caller names and numbers. To get the most from your new phone, please read through this user’s guide. Display Up Menu Delete Store M1 M2 button button button button button button Down button Dial back button Mute button Flash button M4 button M3 button SETTING LANGUAGE OR OR Select Language SETTING FLASH TIME 100/300/1000/600 OR Redial/Pause button Speaker Volume button Speaker button Microphone INSTALLING THE PHONE Your phone should be placed on a level surface, such as a desk or table top, or you can mount it on a wall. Connect the telephone line. OR Select timing SHORT GLOSSARY OF TERMINOLOGY USED IN THIS MANUAL Hook switch. The part of the phone that pops up to activate the phone line when the handset is lifted from the base. The phone is in active mode when the handset is off the base cradle or the SPEAKER feature is on. The phone is in standby mode when the handset is on the base cradle. SETTING TONE/PULSE SETTING THE PHONE WALL MOUNTING 1. Rotate the wall mounting knob as shown below: NOTE: Program the following settings before using the phone. There are 6 options to set: OR OR Select Tone or Pulse T60-EX英文说明书-反面 K3物料编码：N9. 00T60. 04021 旧MRP物料编码：8T60XX-4500 PHONE OPERATION RECEIVING A PHONE CALL CASE 1 Ringing Answer Call End Call DELETING All OUTGOING NUMBER A- Ringer Volume Switch A Press and hold 3 seconds M1/M2/M3/M4 CASE 2 OR Memory Location CALLER ID FEATURES Caller ID (CID) is a service provided by your local telephone company. You have to subscribe this service from your local telephone company before you can use it. This unit can receive caller ID without any setting. Your caller ID information may include the phone number, name, date and time. OR + CHARACTER TABLE key Assigned characters 1 ABC2 key Assigned characters PQRS7 TUV8 WXYZ9 TONE CHECK CONTENT OF MEMORY LOCATION M1/M2/M3/M4 CASE 2 Ringing Answer Call OR REVIEWING INCOMING CALLS End Call OR Select a memory location to display the name and number DELETING A MEMORY LOCATION M1/M2/M3/M4 Reviewing incoming call log DEF3 GHI4 JKL5 OR CASE 3 Ringing Answer Call End Call DIAL BACK A CALLER ID NUMBER CASE 1 OR Select Memory Location 0 Press and hold 3 seconds OR Select the caller number MNO6 CASE 4 Ringing Answer Call OR The number shown will be dialed STORING A TELEPHONE NUMBER M1/M2/M3/M4 TROUBLESHOOTING TIPS No Dial Tone • Check all connections are secure and not damaged. • Make sure the hook switch is fully extended when the handset is lifted from the cradle. No Display • Replace the batteries. [. . . ] • Avoid dropping and other rough treatment to the unit. • Never use a strong cleaning agent or abrasive powder because this will damage the unit. • Retain the original packaging in case you need to ship it at a later date. [. . . ]