User manual ALCATEL TEMPORIS 05

[. . . ] IMPORTANT INSTALLATION INFORMATION CAUTION: Disconnect the phone cord from the wall outlet before installing or replacing the batteries. €¢ • • • Never install telephone wiring during a lightning storm. Never touch non-insulated telephone wires or terminals, unless the telephone line has been disconnected at the network interface. Use caution when installing or modifying telephone lines. [. . . ] REDIALING A NUMBER If you want to call the last number you dialed again (up to 32 digits), use the redial feature. The last number called is automatically redialed. TROUBLESHOOTING TIPS NO DIAL TONE • Check all cabling to make sure that all connections are secure and not damaged. €¢ Check the hook switch: Does it fully extend when handset is lifted from cradle?CALLER ID (CID) FEATURES Visual message waiting indicator Current date Current time New calls Battery compartment MEMORY Before you store a telephone number in memory, make sure the dialing mode is correctly set for the type of service you have. The default dialing mode is tone (touch-tone), so if you have pulse (rotary) service, you must first change the dialing mode. € The following buttons can be stored into any memory location: 0-9. nO DISPLAY • Replace batteries. €¢ Make sure the batteries are properly installed. NO INFORMATION IS SHOWN AFTER THE PHONE RINGS • In order to receive Caller ID records, you must subscribe to the standard name and number Caller ID service available through your local telephone company. €¢ Be sure to wait until the second ring before answering. pHONE DOES NOT RING • Make sure ringer switch is set to HI. €¢ You may have too many extension phones on your line. If there is no dial tone see solutions for “No dial tone. ” OTHER PARTY CANNOT HEAR YOU • Make sure phone cord is securely plugged in. €¢ Make sure extension phones are on the hook at the same time you’re using the phone. It is normal for the volume to drop when additional extension phones are used at the same time. CANNOT DIAL OUT • Make sure the T/P dialing mode is set to the type of phone service you are subscribed to. Used equipment must be disposed of in compliance with current environmental protection regulations. You should return it to your reseller or dispose of it in an approved recycling centre. INSTALLING THE PHONE Choose the best location to install your telephone. Your telephone should be placed on a level surface, such as a desk or table top, or you may mount it on the wall. [. . . ] Pick up the handset and press the mem button or press the dial button. OR Press dial button while the handset is still in the cradle. Press the review button for the desired memory location, lift the handset and the number dials automatically. REVIEWING CID RECORDS • • • • Press either the ▲(+) or ▼(-) down button to view the newest call record. [. . . ]