User manual ALCATEL TEMPORIS 10 PRO

[. . . ] V) any other matter for which it would be illegal or unlawful for ATLINKS to exclude or attempt to exclude liability. PORTUGÛES ITALIANO Ringing light When there is an incoming call, the light on the top of the handset comes on. Note: When connected to a business telephone system (PABX), a red indicator light ( ) blinks to signal the presence of voicemail messages (only applicable for some PABX). SAFETY Do not use your telephone to notify a gas leak when standing in the vicinity of the leak. [. . . ] Please help us protect the environment in which we live. 4 Check that the line cord is correctly connected to the wall jack. 4 Check that the cradle on the handset is not blocked. Ͽ The telephone doesn't ring You cannot hear your correspondent at the same time. 4 Check that the ringer is not switched off (see ringer adjustment). 4 Check that another extension on the installation is not being used IMPOSTAZIONE DEL TEMPORIS 10 Selezione a frequenze vocali/selezione decadica In modalità predefinita il vostro telefono compone il numero in frequenze vocali ( ). Ͽ TECHNICAL SPECIFICATIONS Telephone connection: Appliance designed for connection to an analogue telephone line class TRT3 (telecommunications network voltage) as defined by standard NF EN 60950. Caution, the network voltage is classified as a hazard according to the criteria of this standard. INSTALLING THE TELEPHONE a base and a handset, a telephone cord, an emergency numbers label. 31 On the base, pivot the round plastic part (with a flat screwdriver or small coin) so that the word "wall" can be read correctly. The screws are not supplied in the package. Se la riparazione o la sostituzione si riveleranno impossibili in rapporto alle Your Temporis 10 telephone comprises: Connect one end of the telephone cord (spiral part) to the jack on the bottom of the handset. Connect the other end of the line cord to the wall telephone jack. Ͽ WALL MOUNTING THE TELEPHONE To install the telephone on the wall, run the line cord (straight part) through the 2 slots under the base (bottom). Drill two vertical holes in the wall, 83 mm apart. Insert the anchors then screw in wood screws (diameter: 3 mm, length: 25 mm) without tightening them. Secure the base to the screws pulling it downwards. Ͽ Please readremind you that the guide includedis an appliance approved in We would carefully the user’s Temporis 10 in this package. Temporis 10 with European regulations, to European technical standards, as compliance is certified as conforming as attested to by the CE marking. evidenced by the CE Mark affixed thereto. You thus have a have just bought is a this product and you should contact The product you legal warranty covering technological product, which must be your reseller for handled with care. Any information relating to the said warranty. [. . . ] The repaired or replaced Product or part, which, may be new or refurbished, 41 shall be under warranty for a period of ninety (90) days from the date of repair or replacement, or until the end of the initial warranty period if that exceeds the said ninety (90) days; the warranty period shall also be extended by any period exceeding six days between the date the defective Product is delivered to the seller and the date that the repaired or replaced Product is placed at your disposition. This warranty does not apply in case of: • damage caused by installing or using the Product otherwise than in accordance with the instructions contained in the user’s guide; • improper connection or abnormal use of the Product, in particular together with incompatible accessories, as stipulated in the user’s guide; • a Product that has been opened, modified or fitted with unapproved replacement parts; • removal of the serial number or defacement rendering the serial number illegible; • normal wear and tear, including normal wear and tear of accessories, batteries and screens; • non-compliance with technical and safety standards in force in the geographical area of utilization; • Products having suffered an impact or a fall; • damage caused by lightning, power surge, proximity to a source of heat or radiation, water damage, exposure to excessive temperature, humidity or other environmental conditions or any other cause external to the Product; • negligent or defective maintenance; • damage caused by servicing, modification or repair performed by any person other than an authorized ATLINKS service provider. If the returned Product is not covered by the warranty, you will receive a repair estimate giving the processing cost and the transport fees that will be charged if you wish the Product to be returned to you. This warranty is applicable where the Product is lawfully purchased, in the United Kingdom . [. . . ]