User manual ALCATEL TEMPORIS 55

[. . . ] CASE 2 The number shown will be dialed TROUBLESHOOTING TIPS No Dial Tone Check all cabling to make sure that all connections are secure and not damaged Check hook switch: Does it fully extend when handset is lifted from cradle?No Information is Shown After the Phone Rings Are you subscribed to Caller ID service from your local telephone company?Be sure to wait until the second ring before answering. [. . . ] Temporarily disconnect any equipment connected to the phone, such as faxes, other phones or modems. Last number redial MUTE In off-hook state, user can press the MUTE button to access mute function, when MUTE is on, the MUTE indicator will show on the screen. press the MUTE button to exit mute function and resume normal conversation. INSTALLING AND REPLACING THE BATTERIES Your Caller ID phone uses 3 AA-Size alkaline batteries for receiving and storing Caller ID records and for storing the numbers you use for frequently. IMPORTANT: If you are not going touse the telephone for more than 30 days, remove the batteries because they may leak and damage the unit. CALLER ID FEATURES Caller ID (CID) is a service available from your local telephone company. For Caller ID to work on this system, you must subscribe to Caller ID service. This unit can receive caller ID without any setting. Your Caller ID information may include the phone number, date and time. If the telephone line cord is connected, disconnect it from the base unit. Carefully turn over the phone, use a pen or paper clip to loosen the batter y cover. Open the battery compartment by pushing on the battery cover and sliding it away from the unit. Insert 3 AA-size alkaline batteries (not included) as shown on the diagram in the battery compartment. Snap the battery compartment door back SIZE A A into place. If the line cord was previously connected, SIZE A A reattach it to the unit and check your memory locations. Press and Hold 2 Seconds Enter Year, Month, Day and Time REVIEWING INCOMING CALLS Reviewing Incoming Call Log SETTING PCODE DIAL BACK A CALLER ID NUMBER CASE 1 OR Select the caller number OR GENERAL PRODUCT CARE To keep your phone working and looking good, follow these guidelines: Avoid putting it near heating appliances and devices that generate electrical noise (for example. Avoid dropping and other rough treatment to the unit. Never use a strong cleaning agent or abrasive powder because this will damage the finish. [. . . ] Fix the telephone in the wall as the following layout. Select Timing The number shown will be dialed REVIEWING OUTGOING NUMBERS P HONE O PERATION RECEIVING A PHONE CALL Answer Call End Call M AIN F EATURES FSK/DTMF Caller ID auto detect Incoming call log records up to 68 calls Outgoing call log records up to 15 last dialed numbers 10 two-touch memories On hook pre-dialing Prefix Code Redial Pulse or Tone dialing mode Mute function Speakerphone To get the most from your new phone, you are suggested to take a few minutes right now to read through this user guide. DIAL BACK AN OUTGOING NUMBER CASE 1 OR OR Ringing 2 Answer Call End Call The number shown will be dialed 3 CASE 2 Ringing DELETING A CALLER ID NUMBER O PTIONS M ENU Outgoing call Answer Call CASE 3 Call-log Number End Call Select the number SHORT GLOSSARY OF TERMINOLOGY USED IN THIS MANUAL Hook switch. [. . . ]