User manual ALCATEL XP REPEATER

[. . . ] Press and hold the button for 5 seconds. The repeater will start the registration to the base. NOTE: The registration mode of the repeater could last for 30 minutes for your convenience. 2 Location To get the optimum conditions, the repeater should be placed in a proper location. [. . . ] TROUBLESHOOTING As a general rule, if a problem occurs, unplug and replug the power adapter. Problems The LED on the Alcatel XP Repeater won't stop flashing. Solutions • Move the Alcatel XP Repeater closer to the telephone. € Check for interference from electronic devices. € Make sure the Alcatel XP Repeater is not too close to metal objects or thick walls. € Make sure the Alcatel XP Repeater is within the telephone base's good signal range. € Make sure there is at least 11 metres between Alcatel XP Repeaters. • Make sure the Alcatel XP Repeater is powered on. € Move the Alcatel XP Repeater closer to the telephone base and register it again. • The signal connection is very poor. € Try to find another location where the signal to the telephone base is better. € You may be moving out of the telephone base or Alcatel XP Repeater reception range, or are in a blind spot. Ou si vous voulez, fixer le au mur: 4 CARACTERISTIQUES TECHNIQUES Adaptateur secteur Ten Pao - S004LB0600030 / S004LV0600030 Entrée 100-240 V CA 50/60Hz 150 mA, sortie 6 V CC 300 mA 1, 88 à 1, 9 GHz (largeur de bande = 20 MHz) DECT (Digital Enhanced Cordless Telecommunication) Bande de fréquences Emplacements pour fixation au mur Norme Calls will not handover to the Alcatel XP Repeater. I used to be able to connect to the telephone base, but now I cannot. The audio quality is very poor or noisy when receiving a call. Calls lost or audio becomes poor when moving from the telephone base reception range to the Alcatel XP Repeater reception range. 1 Description du répéteur The store where you bought your telephone can also provide you with information and after-sales support. SAFETY In the event of an electrical hazard, the mains adapter acts as 230V power isolating device. Toutefois, la présente garantie est exclue dans les cas suivants : • une installation ou une utilisation non conforme aux instructions figurant dans ce guide ; • un mauvais branchement ou une utilisation anormale du produit, notamment avec des accessoires non prévus à cet effet ; • une usure normale ; • le non-respect des normes techniques et de sécurité en vigueur dans la zone géographique d’utilisation ; • produits ayant subi un choc ou une chute ; • produits détériorés par la foudre, une surtension électrique, une source de chaleur ou ses rayonnements, un dégât des eaux, l’exposition à des conditions d’humidité excessive, ou toute autre cause extérieure au produit ; • un entretien défectueux, une négligence ; • une intervention, une modification ou une réparation effectuée par une Or if you want to mount the repeater on a wall: Slots for wall mounting It should therefore, as a precaution, be installed close to the appliance and be easily accessible. To disconnect the device from the primary power source, the mains adapter must be removed from the 230V AC / 50 Hz socket. [. . . ] If you are the owner of the appliance, you must deposit it at the appropriate local collection point or leave it with the vendor when buying a new appliance. - If you are a professional user, please follow your supplier's instructions. - If the appliance is rented to you or left in your care, please contact your service provider. Keen to preserve the environment, ATLINKS has equipped this appliance with a switching power supply, offering better energy efficiency. [. . . ]