User manual ALINCO DJ-175 T

[. . . ] VHF FM TRANSCEIVER DJ-175 T/E/TFH Instruction Manual Thank you for purchasing your new Alinco transceiver. This instruction manual contains important safety and operating instructions. Please read this manual carefully before using the product and keep it for future reference. ALINCO, INC. NOTICE / Compliance Information Statement NOTICE / Compliance Information Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] " " is displayed on the LCD, and the channel programmed in MC is recalled. Press the key again or the key in the Call mode to return to original operating mode (VFO/memory). IMPORTANT NOTE: · The dial and direct key-entry of frequency/memory channel are blocked in the Call mode. · It is possible to temporary change the offset and CTCSS/DCS related parameters in the Call mode. · The Scan function is deactivated in the Call mode. · The CALL channel reprogramming is possible but it can't be deleted from the memory channel mode. 27 4. Basic Operation 4. 7 Receiving 1. Press the key and rotate the dial to adjust the audio level as necessary. key and rotate the dial to adjust the squelch level. 4. Select the frequency that you wish to operate by using the dial or the keypad. When a signal is received on the frequency that you selected, and S-meter are displayed on the LCD, then the received signal can be heard. The green RX indicator also lights at this time. 4 4. 7. 1 Monitor Function In case the receiving signal is weak and the audio is intermittently cut off by the squelch, press the MONI key. As long as this key is pressed, the squelch including TSQ/DCS unmutes making the audio easier to hear. · The squelch is unmuted while the MONI key is pressed, regardless of the squelch level setting. · This function unmutes the squelch even if the DCS and Tone Squelch functions are set. 4. 8 Transmitting 1. Select the frequency that you wish by using the dial or keypad. The red TX indicator turns on while transmitting. While holding down the PTT key, speak into the unit at normal voice from the distance of 5cm (2"). Release the PTT key to receive. IMPORTANT NOTE: · To transmit a tone-burst signal, press the MONI key while holding down the PTT key. · Speaking too loud, too close or too far from the unit may distort the audio. · "OFF" appears on the display and a beep sounds when the PTT key is pressed with the TX frequency set out of the TX range. You can not transmit in this state. 28 4. Basic Operation 4. 8. 1 Selecting the Output Level Press the FUNC key, and while is displayed on the LCD, press the key to switch transmission power output. The display changes as follows depending on the output level selected: · is displayed with on the power meter. (Low power output) · is displayed with on the power meter. [. . . ] *The design of the AC adapter may vary depending on the models. Connect the adapter to an outlet. AC adapter* AC adapter plug Basket 3. Mount the battery (with or without being attached to the unit) in the basket as shown. The red indicator on the basket turns on and charging starts. 10 Indicator 53 10. Maintenance and Reference 4. [. . . ]