User manual ALINCO DJ-F1T

[. . . ] Always wear ear protection if the sound pressure exceeds 85 dB(A). When using mains-powered tools, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock, personal injury and material damage. Read all of this manual carefully before operating the tool. Before operating the tool, make sure that you know how to switch the tool off in an emergency. [. . . ] Only use router bits with a shank diameter equal to the size of the collet installed in the tool. Only use router bits suitable for the no-load speed of the tool. Never use router bits with a diameter exceeding the maximum diameter specified in the technical data section. do not use the tool in an inverted position. Do not attempt to use the tool in a stationary mode. Take special care when routing MDF or surfaces coated with lead-based paint: - Wear a dust mask specifically designed for protection against lead paint dust and fumes and ensure that persons within or entering the work area are also protected. - Do not let children or pregnant women enter the work area. - Do not eat, drink or smoke in the work area. Additional safety instructions for Australia and New Zealand x This appliance is not intended for use by young or infirm persons without supervision. Children must be supervised to ensure they do not play with the appliance. X If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. N) x Fit the distance piece (21) to the base of the router using the screws provided. Dust extraction adaptor ASSEMBLY Before attempting any of the following operations, make sure that the tool is switched off and unplugged and that the spindle has stopped. X Fit the centring pin (22) to the workpiece side of the edge guide with the screw (23) provided. X Fit the `L' bar (24) to the upper side of the edge guide using the two screws and nuts provided. X Fit the rotating attachment (25) to the `L' bar with the wing screw provided. X Read the starting position from the scale (11). X Add the desired depth of cut to the starting position. X Pull the plunge lock lever (4) up and let the router return to its original position. X After switching the router on, plunge it down and make the desired cut. Carefully guide the cable in order to avoid accidentally cutting it. E) The depth of cut is the distance X between the depth stop bar (9) and the depth stop (18). [. . . ] Description Application Grooves and rebates Trimming laminates or hardwood; accurate profiling using a template Rebates on straight or curved workpieces Grooves, engraving and edge bevelling Fluting, engraving and decorative edge moulding Decorative edge moulding Decorative edge moulding Rounding over edges Dovetail joints Chamfer edges MAINTENANCE Your Black & Decker tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. Before performing any maintenance, switch off and unplug the tool. Regularly clean the ventilation slots in your tool using a soft brush or dry cloth. [. . . ]