User manual ALINCO DJ-S1E

[. . . ] For this reason the instructions given should be regarded as a guide to the installation, use and maintenance of the machine indicated on the front cover. This document applies to the standard version of this machine. The manufacturer therefore accepts no liability for any damage arising from specifications that deviate from the standard version of the machine as delivered to you. Every possible care has been taken in the production of this document, but the manufacturer accepts no liability for any errors in this document or for any consequences arising therefrom. [. . . ] ­ When the coffee­making cycle has been finished, the setting returns to the default setting. GB TIP ­ When the container and/of the spray head are not in the correct position, a signal sounds and flashes on the display. ­ Also this selected time setting has been protected, so that no one can cancel the setting between times, see the previous tip at § 7. 1. 1. ­ Permanent changing of the default settings is described in the extended programming mode § 7. 3. 18 version 1. 0 ECopyright Bravilor Bonamat B. V. 7. 2 The limited programming menu ­ Press the selection key (M. ) to counter­clockwise to the next setting (§ 7. 2. 2). By pressing a selection key several times, the entire carousel (fig. 12 ) can be gone through. ­ The settings are described in the order of the carousel, counter­clockwise (fig. 12 ). ­ With the red stop key (K. ) the programming can always be interrupted and stopped. The programme then returns to the users' menu (§ 7. 1). ­ When nothing happens in the programming menu for 20 seconds, the programme returns to the users' menu (§ 7. 1). Non­confirmed settings are not saved. ­ When the symbol appears in the menu, the setting can be set to zero by simultaneously pressing both selection keys (M. ) and (N. ). ­ The day and total counters only give the amounts in litres. D Press the confirmation key (L. ) to confirm that the container is empty. ­ A signal sounds, the hammer symbol flashes and a funnel appears on the display (fig. 19 ). GB ­ Make sure that the spray head is in the correct position above the empty container with empty filter unit. ­ Desolve 100 g of descaler in 0. 75 litre lukewarm water (about 40°C). Stir the descaling solution, so that it is well desolved. ­ When during the descaling programme a signal sounds, an operation is to be carried out. Finish the operation by pressing the confirmation key (L. ). ­ When the level blocks on the display start flashing, the coffee container is to be emptied. G H I J K L M N Fig. 18 Starting the descaling programme coffee­making system D After having entered the operators' PIN code, press selection key (M. ) twice. ­ The descaling programme appears on the display (fig. 18 ). ­ The symbol dP starts flashing and the enter symbol appears on the display. D Press confirmation key (L. ) to start the descaling programme. [. . . ] Set the correct amount, see § 7. 3. 1. Set the drip time again, see § 7. 3. 10. Set the drip time again, see § 7. 3. 10. 3. Coffee is too cold. Plug of the container is not connected to the column. [. . . ]