User manual ALLEN & HEATH XONE 464

[. . . ] USER GUIDE Publication AP4147 Limited One Year Warranty This product has been manufactured in the UK by ALLEN & HEATH and is warranted to be free from defects in materials or workmanship for period of one year from the date of purchase by the original owner. To ensure a high level of performance and reliability for which this equipment has been designed and manufactured, read this User Guide before operating. In the event of a failure, notify and return the defective unit to ALLEN & HEATH or its authorised agent as soon as possible for repair under warranty subject to the following conditions Conditions Of Warranty 1. The equipment has been installed and operated in accordance with the instructions in this User Guide 2. [. . . ] Turn fully anticlockwise to turn the signal off, fully clockwise for a maximum +6dB boost. Each of the 6 aux mixes has its own dedicated channel level control. Note that Auxes 3-4 and 5-6 are fed as a stereo pair from the stereo channels. Adjust the two related level controls when feeding the mono channel to a stereo aux. Aux 5-6 can be switched pre or post-fade. With the switch in the up position the post-fader channel signal is routed. Press the switch to select the pre-fader signal instead. Set the switch to POST to send to external effects devices such as reverb processors. The amount of signal sent to the device follows the fader level. The processed (wet) signal returned to the mix elsewhere is therefore in proportion to the direct (dry) routed signal regardless of fader position. Postfade sends are also used to provide zone or recording feeds where the outputs should follow the fader movements. Set the switch to PRE to send to monitors such as stage or remote foldback or recording cue. The amount of signal in the monitor mix is independent of the fader movements. therefore adjustments made to the main mix will not affect the balance of the monitors. Note that selected channels in a monitor mix can still be set post-fader if required, for example to prevent `dressing room' talk when working with radio microphones. The pre-fade sends are set post-EQ post-ON as standard. These can be reconfigured pre-EQ and/or pre-ON by resoldering internal links. PAN Positions the channel signal between left and right in the stereo mix to create the required image. The centre (mono) position is detented for quick resetting. The green LED lights when the channel is turned on. All outputs except the insert send and Cue are muted when the channel is turned off. Note that the pre-fade aux sends can be internally reconfigured so that they are not affected by this switch if required. PEAK The red LED lights when the channel is within 9dB of clipping. [. . . ] If the earthing is solid to start with you are less likely to experience problems. Use high grade AUDIO CABLES and check them for reliable connection. It is well known that many audio system problems are due to faulty cables and connectors. In a club or similar installation strict SOUND LEVEL and noise regulations may apply. Check that your system levels are correctly set up to comply. [. . . ]