User manual ALPATEC B-C 01 I

[. . . ] Do not use it near a shower, a bathtub or a swimming-pool. ⷠNever use the appliance on or near hot surfaces. Do not clean the appliance with abrasive chemicals. ⷠDo introduce neither metallic objects, nor fingers inside the appliance in order to protect you from electrical shock. [. . . ] Children, the disabled and the elderly are at highest risk of being scalded. CAUTION : Do not plug in the power cord or turn on the power switches when the waterdispenser is empty. The water dispenser should be moved by holding it on both sides with both hands, instead of lifting it at the top with one hand. 5cm) of space between the back of the water dispenser and the wall to allow proper air circulation. Do not install the water dispenser where the temperature will go below 50°F (10°C) or above 100°F (38°C). Install the water dispenser on a level floor or counter strong enough to support it when fully loaded. Do not install where it will be subject to direct sunlight, heat or moisture. The set temperature is reached when it is ON Heating power switch Cooling power switch Cooling is in progress When it is ON the set temperature is reached when it is ON --Cooling power switch the set temperature is reached when it is ON Heating power switch --F 500 FT Cool & Normal Indicates power ON F 500 CT Hot & Normal Heating is in progress when it is ON. NOTE : To use hot water function and cool water function, press 0/I button on the back side of appliance (13 and/or 14) when the button is on "I" or "marche" position, the appliance is switch on. when the button is on "0" , the appliance is switch off. The words `froid" and "chaud" are only indication. After complete draining, fit on the plug, cover and screw again. warning: · Do not hold the dispenser up side down to drain the water. It may cause the water flow about the inside unit and short circuit may occurs. Before turning on the power supply and connect the power switch on the water dispenser, make sure there is a bottle with sufficient water on the water dispenser, and water can flow out from both taps. Periodically the water dispenser tanks must be sanitized to prevent unpleasant tastes in the water and cleaned to remove mineral deposits that can impair flow. Before cleaning, set the power switch to off, and unplug the power cord. For a water dispenser used for the first time, go to Step 5. Completely drain the water from the bottle on the water dispenser, and remove the bottle. Do not directly inject bleaching powder into the water dispenser, as concentrated bleaching powder solution may damage plastics. Fill a 2L bottle with water, and add about 2. Fit an adaptor onto the bottle and place it on the water dispenser (See Loading the dispenser). [. . . ] Drain water from the water tank of the water dispenser (see Drain from water dispenser), put on the plug, fit the bottom cover and screws with a screwdriver. Operate as per "Loading the dispenser", and the water dispenser can be used normally. CAUTION The power supply to the water dispenser can be turned ON only when water can flow out from both taps of the water dispenser homogeneously. Push the plug completely into the outlet. [. . . ]