User manual ALPATEC ISSIMO 9

[. . . ] Do not use it near a shower, a bathtub or a swimming-pool. ⷠNever use the appliance on or near hot surfaces. Do not clean the appliance with abrasive chemicals. ⷠDo introduce neither metallic objects, nor fingers inside the appliance in order to protect you from electrical shock. [. . . ] ⷠWipe up any water spills immediately after loading or unloading water bottles. ⷠDo not use with water that is microbiologically unsafe or of unknown quality. Children, the disabled and the elderly are at highest risk of being scalded. ⷠAllow at least 1" (2. 5cm) of space between the back of the water dispenser and the wall to allow proper air circulation. ⷠDo not install the water dispenser where the temperature will go below 10°C or above 32°C. ⷠInstall the water dispenser on a level floor or counter strong enough to support it when fully loaded. ⷠDo not install where it will be subject to direct sunlight, heat or moisture. Do not plug in the power cord or turn on the power switches when the waterdispenser is empty. First time to cool / first time to warm 40 - 45 min 9 min Make sure the dispenser is unplugged with both the hot and cold power switched off. ⷠWash hands and wipe the adaptor and the top of the bottle with a clean cloth. After complete draining, fit on the plug, cover and screw again. Do not hold the dispenser up side down to drain the water. It may cause the water flow about the inside unit and short circuit may occurs. Before turning on the power supply and connect the power switch on the water dispenser, make sure there is a bottle with sufficient water on the water dispenser, and water can flow out from both taps. Periodically the water dispenser tanks must be cleaned to prevent unpleasant tastes in the water and to remove mineral deposits that can impair flow. Before cleaning, set the power switch to off, and unplug the power cord. For a water dispenser used for the first time, go to Step 5. Do not directly inject bleaching powder into the water dispenser, as concentrated bleaching powder solution may damage plastics. Fill a 2L bottle with water, and add about 2. Fit an adaptor onto the bottle and place it on the water dispenser (See Loading the dispenser). Press the hot water key, cold water key and cool water key (depending on respective types), so that water flows out homogeneously from both taps of the water dispenser. [. . . ] Drain water from the water tanks of the water dispenser (see Drain from water dispenser), put on the plug, fit the bottom cover and screws with a screwdriver. Operate as per "Loading the dispenser", and the water dispenser can be used normally. CAUTION The power supply to the water dispenser can be turned ON only when water can flow out from both taps of the water dispenser homogeneously. Push the plug completely into the outlet. [. . . ]