User manual ALPINE CDE-9841R

[. . . ] FOR CAR USE ONLY/NUR FÜR AUTOMOBIL GEBRAUCH/POUR APPLICATION AUTOMOBILE UNIQUEMENT/ PARA USO EN AUTOMÓVILES/SOLO PER L'UTILIZZO IN AUTOMOBILE/ENDAST FÖR BILBRUK R RDS MP3/WMA CD Receiver EN CDE-9845RB/CDE-9845RR RDS MP3 CD Receiver DE CDE-9843R/CDE-9843RM FM/MW/LW/RDS CD Receiver FR CDE-9841R · OWNER'S MANUAL Please read before using this equipment. · BEDIENUNGSANLEITUNG Lesen Sie diese Bedienungsanleitung bitte vor Gebrauch des Gerätes. · MODE D'EMPLOI Veuillez lire avant d'utiliser cet appareil. · MANUAL DE OPERACIÓN Léalo antes de utilizar este equipo. [. . . ] *1 When the subwoofer mode is set to OFF, its level cannot be adjusted. 2 Turn the Rotary encoder (CDE-9845RX) or press 4 and 3 (CDE-9843RX/CDE-9841R) until the desired sound is obtained in each mode. By setting Defeat ON, previously adjusted settings of BASS and TREBLE will return to the factory defaults. Setting the Bass Control g CENTER f. f You can change the bass frequency emphasis to create your own tonal preference. 1 CDE-9843RX/CDE-9841R BAND 4 CDE-9845RX: Press CENTER f. to select the Bass Control mode. BASS TREBLE normal mode BASS CDE-9843RX/CDE-9841R: Press MODE/LOUD to select the Bass Control mode. BASS TREBLE SUBW BALANCE FADER DEFEAT VOLUME BASS 2-1 g f MODE/LOUD 3 Setting the bass centre frequency: Press g or f to select the desired bass centre frequency. 60Hz 80Hz 100Hz 120Hz 60Hz The displayed bass frequency is emphasized. Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/ Defeat 2-2 Setting the bass band width (Q-Factor): Press BAND to select the desired bass band width. 1 2 3 4 (Narrow) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (Wide) 1 Press Rotary encoder (MODE/LOUD) (CDE9845RX) or MODE/LOUD (CDE-9843RX/CDE9841R) repeatedly to choose the desired mode. Each press changes the modes as follows: BASS TREBLE SUBW*1 BALANCE FADER DEFEAT VOLUME BASS Bass Level: -7 ~ +10 Treble Level: -7 ~ +7 Subwoofer : 0 ~ +15 Balance : L15 ~ R15 Fader : R15 ~ F15 Defeat : ON/OFF Volume : 0 ~ 35 Changes the boosted bass band width to wide or narrow. A wide setting will boost a wide range of frequencies above and below the centre frequency. A narrower setting will boost only frequencies near the centre frequency. 2-3*2 Setting the bass level: Turn the Rotary encoder (CDE-9845RX) or press 4 and 3 (CDE-9843RX/CDE-9841R) to select the desired bass level (-7~+10). You can emphasize or weaken the bass frequency. · If the Rotary encoder (MODE/LOUD) or MODE/LOUD is not pressed within 5 seconds after selecting the BALANCE, FADER, DEFEAT or SUBWOOFER mode, the unit automatically returns to normal mode. CDE-9845RX: · If the Rotary encoder (MODE/LOUD) is not pressed within 5 seconds after selecting the BASS or TREBLE mode, the unit automatically returns to normal mode. · If no operation is performed within 15 seconds, the bass control setting will be turned off automatically. · The bass level settings will be individually memorized for each source (FM, MW (LW), CD, etc. ) until the setting is changed. The bass frequency and bass band width settings adjusted for one source are effective for all other sources (FM, MW (LW), CD etc. ). · This function is inoperable when DEFEAT is set to ON. *2 CDE-9845RX: The adjustment can also be made by pressing the Rotary encoder (MODE/LOUD). Refer to "Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/Defeat" (this page). 14-EN Setting the Treble Control You can change the Treble Frequency emphasis to create your own tonal preference. Turning Loudness On/Off Loudness introduces a special low- and high-frequency emphasis at low listening levels. This compensates for the ear's decreased sensitivity to bass and treble sound. 1 CDE-9845RX: Press CENTER f. to select the Treble Control mode. BASS TREBLE normal mode BASS Press and hold Rotary encoder (MODE/LOUD) (CDE-9845RX) or MODE/LOUD (CDE-9843RX/CDE9841R) for at least 2 seconds to activate or deactivate the loudness mode. The display shows "LOUD ON" when the loudness mode is activated. CDE-9843RX/CDE-9841R: Press MODE/LOUD to select the Treble Control mode. BASS TREBLE SUBW BALANCE FADER DEFEAT VOLUME BASS 2-1 Setting the treble Centre frequency: Press g or f to select the desired treble centre frequency. 7. 5kHz 10. 0kHz 12. 5kHz 15. 0kHz 7. 5kHz The displayed Treble frequency is emphasized. 2-2*2 Setting the treble level: Turn the Rotary encoder (CDE-9845RX) or press 4 and 3 (CDE-9843RX/CDE-9841R) to select the desired treble level (-7~+7). You can emphasize the treble frequency. · If no operation is performed within 15 seconds, the treble control setting will be turned off automatically. · The treble level settings will be individually memorized for each source (FM, MW (LW), CD, etc. ) until the setting is changed. The Treble frequency settings adjusted for one source are effective for all other sources (FM, MW (LW), CD, etc. ). · This function is inoperable when DEFEAT is set to ON. *2 CDE-9845RX: The adjustment can also be made by pressing the Rotary encoder (MODE/LOUD). Refer to "Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/Defeat" (page 14). 15-EN Other Functions CDE-9845RX -/J Rotary encoder *1 Displayed during playback of a disc with CD Text. "NO TEXT" will be displayed when the CD contains no Text data. *2 "ROOT " is displayed for a folder that does not have a folder name. [. . . ] Otros Q15. Comments Q15. Kommentar: Q15. Commentaires Q15. Comentarios Scheda informazioni prodotto Italiano La compilazione di questa formulario è volontaria. Se compilate questo formulario, ritornandolo ad Alpine, i Vostri dati saranno raccolti in un file di riferimento per lo sviluppo dei nuovi prodotti Alpine. In aggiunta Voi potrete ricevere in futuro informazioni riguardanti i nuovi prodotti o la richiesta di una Vostra opinione circa i prodotti o i servizi forniti da Alpine. Se siete d'accordo, Vi preghiamo di ritornarci il formulario completato negli appositi spazi con i Vostri dati. [. . . ]