User manual ALPINE CDM-7854R

[. . . ] R CDM-7857RB CDE-7855RB CDE-7854RM CDE-7854R FM/MW/LW/RDS CD Receiver · OWNER'S MANUAL Please read before using this equipment. EN DE FR ES INTLZ PWR SOU IND RCE RDS 44WATTS x 4AMPLIFIER PTY T. INFO AF NEWS F MONO TUNE A. ME MODE/LOUD BAN D AF T. INFO NEWS RPT ALL M. I. X. DX SEEK EON TP ST MO LOUD CD RECEIVER 1 M. I. X. 2 RPT 3 SCAN 4 5 6 IT DN UP (CDM-7857RB) ALPINE ELECTRONICS, INC. Tokyo office: 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-8501, Japan Tel. : (03) 3494-1101 ALPINE ELECTRONICS OF AMERICA, INC. [. . . ] Press the F button to activate the normal mode. Make sure that the F button lights red, then press the preset location button in which your desired RDS station is preset. If the preset station's signal is weak, the unit automatically searches and tunes to a stronger station in the AF (Alternative Frequencies) list. If the preset station and the stations in the AF list cannot be received: The unit searches again for a station in the PI (Programme Identification) list. If there are still no stations receivable in the area, the unit displays the frequency of the preset station and the preset indicator disappears. If the signal level of the Regional (Local) station being tuned becomes too weak to receive, press the same preset location button to tune in a Regional station in other district. NOTE For presetting the RDS stations, refer to the Radio Operation section. The RDS stations can be preset in the F1 and F2 bands only. When the RDS station signal received has become weak: · AF seek mode, press and hold the AF button for at least 2 seconds to have the unit automatically seek a stronger station in the AF (Alternative frequencies) list. If there is no AF station, the display shows "SEEK END. " 5 4 5 Press the AF button again to deactivate the RDS mode. Press the F button to activate the normal mode. The F button returns to red. 8-EN 4/6-12 CDM-7857RB 8 99. 9. 27, 3:14 PM Receiving RDS Regional (Local) Stations 2 1 2 3 1 2 Press and hold the INTLZ button for at least 3 seconds to activate the setting mode. Press the Preset 2 button to turn on or off the REG (Regional) mode. In the REG OFF mode, the unit automatically keeps receiving the related local RDS station. Press the INTLZ button to deactivate the setting mode. Press the DN g and f UP buttons within 5 seconds after activating the PTY mode to choose the desired programme type while the PTY (programme type) is being displayed. Each press scrolls the programme type by one. LIGHT M CLASSICS OTHER M Press the PTY button within 5 seconds after selecting the programme type to start searching for a station in the selected programme type. The chosen programme type indicator blinks during searching and lights when a station is found. If no PTY station is found, "NO PTY" will be displayed for 2 seconds. 3 Receiving Traffic Information Press the T. INFO button repeatedly until the T. INFO indicator appears in the display. Press the DN g or f UP button to select your desired traffic information station. When a traffic information station is tuned in, the TP indicator lights up. Traffic information is heard only when it is being broadcast. If traffic information is not being broadcast, the unit is set in the standby mode. When a traffic information broadcast begins, the unit automatically receives it and the display shows "TRF-INFO" for a few seconds and returns to the PS display. [. . . ] (Refer to Operating Instructions, page 5) Linked with volume operation. CDE-7855RB/CDE-7854RM/CDE-7854R CDM-7857RB 18-EN 6/15-19 CDM-7857RB 18 99. 9. 27, 3:15 PM 1 Antenna Receptacle Connect to the supplied ISO antenna convertor plug. 2 Audio Interrupt In Lead (Pink/Black) Connect this lead to the Audio Interface output of a cellular phone which provides ground shorting when a call is received. If a device having the interrupt feature is connected, audio will be automatically muted whenever the interrupt signal is received from the device. 3 Remote Turn-On Lead (Blue/White) Connect this lead to the remote turn-on lead of your amplifier or signal processor. [. . . ]