Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ALPINE HTC-221GN. We hope that this ALPINE HTC-221GN user guide will be useful to you.
Lastmanuals help download the user guide ALPINE HTC-221GN.
Detailed instructions for use are in the User's Guide.
[. . . ] Remove and retain rear A/C control assembly. Assembly housing is secured with (2) two spring cli on front of housing. Pull down to disengage, then slid forward to clear bracket. Disconnect wiring and set assembly in a safe place for re-use later. [. . . ] Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to C-pillar. Route the power lead to an accessory controlled source. Connect the ground lead to the vehicle chassis. Route thePHOTO 3 wiring to the VCP location. Connect per instructions included remaining
4
with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna.
12. Install block-off cover (item 9 pg 2) and secure using (2) two # 8 x 9/16" screws (item 2 pg 2) at rear area. Detach A/C wire harness from brace to allow connectors to reach the new A/C control location. Install mounting bracket (item 8 pg 2 ) by inserting tabs into slots in O. E. bracket and securing front of bracket using (2) two screws O. E. screws removed in step 4 into their original location and (1) one #8x 1" screw (itemPHOTO)5in rear location. Install convoluted tube (item 5 pg 2) around wire harness to prevent chaffing against bracket. PREPARATION OF CONSOLE
5
PHOTO 6
.
16. Remove A/C control from rear bezel assembly previously removed in step 1. Modify A/C control by drilling (3) three 1/8" dia. Place A/C control in opening in console (item 10 pg 2). Make sure control is centered and secure using (5) five # 6 X 3/8" screws (item 1 pg 2). INSTALLATION OF CONSOLE
.
Caution: Use extra support for the console until secured to the vehicle. [. . . ] Insert monitor housing into opening in console. Note : Make sure wires do not get pinched Between housingPHOTO 9 and console. Align holes in housing with clips in mounting bracket. Secure using (4) four 8-32x 1 1/2" screws (item 4 pg. 2). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ALPINE HTC-221GN
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ALPINE HTC-221GN will begin.
