User manual ALPINE INA-N333R SOFTWARE

[. . . ] ENGLISH Precautions Important Information, Please Read Carefully Before Using This Product. This product is intended to safely provide turn by turn instruction to get you to a desired destination. Please read the following precautions to ensure that you use your navigation system correctly. L This product is not a substitute for your personal judgment. Any route suggestions made by the navigation system may never supersede any local traffic regulations or your personal judgment and/or knowledge of safe driving practices. Do not follow route suggestions if the navigation system instructs you to perform an unsafe or illegal manoeuvre, places you in an unsafe situation, or routes you into an area which you consider unsafe. [. . . ] Press the OK button or MODE knob to execute the selection. Select "System Setup" from the "Navigation Setup" menu by moving the Flipper switch up or down. Press the OK button or MODE knob to execute the selection. Time to Dest. " from the "System Setup" menu and press the OK button or MODE knob to execute the selection. The displayed screen changes to the "Est. Select "Arrival" or "Remaining" from the menu and press the OK button or MODE knob to execute the selection. : the anticipated arrival time will be set, and the indicator is shown in the guidance display. Remaining : the estimated remaining time will be set, and the indicator is displayed on the guidance display. Arrival 3 The displayed screen changes and the added waypoints are displayed. Press the OK button or MODE knob to set the added waypoints. The route searching starts. 4 5 Note Before setting the point, you can move the location of the added waypoint by moving the cursor with the Flipper switch. Tips · After setting the waypoint, each time you move the Flipper switch up, the direction and distance to the waypoint, and the anticipated required time that you have set is displayed. (The required time is only displayed when you are driving with the route guidance. ) 6 To return to the previous screen, press the RTN button. MENU" screen, press the MENU button. · If "Arrival" is set in the "Setting the Display for the Destination Time" section (this page), the anticipated arrival time is displayed. 17-EN Route Setting/Route Editing 4 OK MODE Flipper switch The system starts to search for a new round-about route in the vicinity of the vehicle. Changing the Searching Conditions Use this when you want to change the route preference while you are driving receiving route guidance. (For example, if the route preference is set to "Quick", and you want to change to another route preference. ) MENU RTN 1 2 3 4 Press the MENU button to display "NAV. MENU. " Select "Edit Route" from "NAV. MENU" by moving the Flipper switch up or down. Press the OK button or MODE knob to execute the selection. Select "Search Condition" from the "Edit Route" menu by moving the Flipper switch up or down. Press the OK button or MODE knob to execute the selection. Set your preference (Quick, Short, Alternative) from the "Search Condition" menu. Checking the Route by List With this detailed list you can find the route, road name and the distance between the points. 1 2 3 4 After setting the route, press the MENU button to display "NAV. MENU. " Select "Edit Route" from "NAV. MENU" by moving the Flipper switch up or down. [. . . ] Drive for a while with GPS signal reception. Moisture condensation The present vehicle position cannot be measured correctly. The vehicle position changed after the ignition was switched off. · Movement on a ferry boat · Rotation of a parking lot turntable · Movement by tow truck Poor satellite configuration Measurement is 2 dimensional The disc is dirty. The pickup lens is dirty. The measurement error is too large. [. . . ]