User manual ALPINE MRP-M500

[. . . ] OWNER'S MANUAL Please read this manual to maximize your enjoyment of the outstanding performance and feature capabilities of the equipment, then retain the manual for future reference. Please read this OWNER'S MANUAL thoroughly to familiarize yourself with each control and function. We at ALPINE hope that your new MRP-M1000/MRPM500 will give you many years of listening enjoyment. In case of problems when installing your MRP-M1000/ MRP-M500, please contact your authorized ALPINE dealer. [. . . ] 1 Right terminal cover 2 Left terminal cover 3 Screw (M3 x 12) NOTE: Do not lift or carry the unit by the attached terminal covers. Before making connections, be sure to turn the power off to all audio components. Connect the yellow battery lead from the amp directly to the positive (+) terminal of the vehicle's battery. Do not connect this lead to the fuse block. Locate the unit and route the leads at least 10 cm (3-15/16") away from the car harness. ⷠKeep the battery power leads as far away from other leads as possible. ⷠConnect the ground lead securely to a bare metal spot (remove any paint or grease if necessary) of the car chassis. ⷠIf you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information. ⷠYour Alpine dealer knows best about noise prevention measures so consult your dealer for further information. 1 RCA Input Jacks Connect these jacks to the line out leads on your head unit using RCA extension cables (sold separately). Be sure to observe correct channel connections; Left to Left and Right to Right. Be sure to observe correct speaker output connections and phasing in relation to the other speakers in the system. Do not connect speaker leads together or to chassis ground. 3 Battery Lead (Sold Separately) Be sure to add a }100 amp fuse as close as possible to the battery's positive (+) terminal. This fuse will protect your vehicle's electrical system in case of a short circuit. If you need to extend this lead, only use }}21mm2 (the wire gauge) for this connection. 4 Remote Turn-On Lead (Sold Separately) Connect this lead to the remote turn-on or power antenna (positive trigger, (+) 12V only) lead of your head unit. 5 Ground Lead (Sold Separately) Connect this lead securely to a clean, bare metal spot on the vehicle's chassis. Verify this point to be a true ground by checking for continuity between that point and the negative (­) terminal of the vehicle's battery. Ground all your audio components to the same point on the chassis to prevent ground loops. Only use }}21mm2 (the wire gauge) for this connection. [. . . ] If any of the above conditions exist, the remote turn-on lead of your MRP-M1000/MRP-M500 must be connected to a switched power source (ignition) in the vehicle. Be sure to use a 3A fuse as close as possible to this ignition tap. Using this connection method, the MRP-M1000/MRP-M500 will turn on and stay on as long as the ignition switch is on. If this is objectionable, a SPST (Single Pole, Single Throw) switch, in addition to the 3A fuse mentioned above, may be installed in-line on the MRP-M1000/ MRP-M500 turn-on lead. [. . . ]