User manual ALTEC LANSING 15595A SIGNAL PROCESSING

[. . . ] : For units purchased in European Union or Asia, this warranty runs for two years from the date of purchase. For units not purchased in Europe or Asia, this warranty runs for one year from the date of purchase. The term of any warranties implied by law shall expire when your limited warranty expires. Some states and/or Member States in the European Union do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. [. . . ] Can also be used to connect a DVD player that has an optical output but not a coaxial output. Use to connect to a DVD player with audio an analog output. Use to connect to a TV or satellite tuner with audio analog output. Use to connect to an auxiliary sound source such as a VCR or CD player with analog audio output. This section describes the function of each control on the remote control used to control the 15595A SIGNAL PROCESSING. Note: You can also control other components using the remote control once you set the appropriate remote control codes. This section provides guidelines for locating and installing your new 15595A SIGNAL PROCESSING. The 15595A SIGNAL PROCESSING creates a realistic surround sound experience from a single unit by using Dolby's Virtual Speaker technology. While placement is less critical than similar systems, the following general guidelines should be followed where possible to ensure best sound quality. Avoid placement where furniture or other items would obstruct the grill area. Center the 15595A SIGNAL PROCESSING below the TV so that dialogue appears to be coming from it. Ensure that the stand being used can support the weight of the TV, the 15595A SIGNAL PROCESSING and any other items it will be required to support. Note: Consult the instructions supplied with the stand for details on how to install the stand and how to mount the 15595A SIGNAL PROCESSING and the TV on the stand. NOTE: Placement of this product on wood surfaces with certain types of finishes, such as clear varnish, may result in damage to the finish. Consult the furniture manufacturer's care instructions for direction as to the types of objects that may safely be placed on the wood surface. Altec Lansing shall not be responsible for any damage to wood surfaces from contact with this product. Use an optical cable to connect the OPTICAL IN (AUX) jack on the 15595A SIGNAL PROCESSING to the optical output jack on a digital audio source such as a game console or digital video recorder. Note: When connecting a DVD player we recommend using the coaxial input found on the rear of the 15595A SIGNAL PROCESSING. However, if your DVD player only has an optical output it can be connected to the AUX input. Note: If you connect the 15595A SIGNAL PROCESSING to the analog audio and digital audio output jacks of the same source equipment such as a DVD player the digital audio output will take priority over the analog audio signal. This is not a typical case as we would recommend using the digital output. If the device you are connecting does not have a digital output or if all of the digital inputs on the 15595A SIGNAL PROCESSING are being used, we recommend using the analog output. [. . . ] If the code number is not valid the LED flashes twice and turns on; · Check to see that the remote can control the device that was programmed by using the CH+/­ or similar button to control the device that was programmed. If it does not control the device, repeat this procedure. Note: If you want to leave the setup mode, press the device button (TV, SAT/CAB, DVD, etc. If you do not press any buttons after 10 seconds, SETUP MODE exits automatically. [. . . ]