User manual ALTEC LANSING 1632C SIGNAL PROCESSING

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. This Class B digital apparatus complies with Canadian ICES-003. The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Caution: To prevent the risk of electric shock, do not remove cover (or back). [. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for the replacement of the obsolete outlet. Protect the power cord from being walked on or pinched -- particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Do not install in an area which impedes the access to the power plug. Disconnecting the power plug is the only way to completely remove power to the product and must be readily accessible at all times. Power source ­ Use only power supplies of the type specified in the operating instructions or as marked on the appliance. If a separate power supply is included with this apparatus, do not substitute with any other power supply ­ use only manufacturer-provided power supplies. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. A blue LED will light around the button when the power is on. Note: To avoid hearing a popping sound when you turn on your inMotion iM9, always turn on your audio source first. Turn off the inMotion iM9 by pushing the power button located on the top of the unit. During battery-only operation the inMotion iM9 automatically shuts down if no audio is detected for three minutes. nOTE: The Auto Shut-down feature is active during battery-only operation. If the AC wall adapter is used, the inMotion iM9 will remain on until it is turned off by pushing the power button located on the top of the unit. The inMotion iM9 system includes a pass-through video feature that allows you to display videos and photos from your iPod onto a television set. To connect the iM9 to a television set or VCR, follow the steps below: 1. Make sure the power to your television set or VCR is turned off. Connect one end of the Composite (RCA) cable to the Composite (RCA) port on the back of the inMotion iM5 system and the other end to the yellow Composite (RCA) input on your television set or VCR. Adjust the iPod cradle by moving the cradle lever to the position corresponding to the type of iPod being used. [. . . ] A blue LED will light around the button when the power is on. Install four C batteries (not included) into the battery compartment on the bottom of the inMotion iM9. Make sure the batteries are installed as illustrated in the battery compartment. Turn on the inMotion iM9 by pushing the power button located on the top of the unit. [. . . ]