User manual ALTEC LANSING 1678C SIGNAL PROCESSING

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. This Class B digital apparatus complies with Canadian ICES-003. The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Caution: To prevent the risk of electric shock, do not remove cover (or back). [. . . ] Disconnecting the power plug is the only way to completely remove power to the product and must be readily accessible at all times. Power source -- Use only power supplies of the type specified in the operating instructions or as marked on the appliance. If a separate power supply is included with this apparatus, do not substitute with any other power supply -- use only manufacturerprovided power supplies. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. For service, refer to qualified service personnel, return to the dealer, or call the Altec Lansing service line for assistance. For products which incorporate batteries, please refer to local regulations for proper battery disposal. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. : This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Please note that in the European Union, you as a consumer might have other legal rights under national legislation of European Union Member States governing the sale of Altec Lansing's goods. The "+" and "­" buttons on the iM7BLK system are the master volume controls for the speaker system. In order to use the remote control, install the supplied battery in the remote's battery compartment. Use one of the following two options to power your iM7BLK: The stand-by button can be used to turn the unit on and place the unit in stand-by mode. An LED will light on the iM7BLK when the unit is on. Insert the barrel connector from the power supply into the DC connector on the rear of the iM7BLK. After this connection is made, insert the power supply into a wall outlet. The "+" and "­" buttons marked with the word "volume" control the master volume. Install eight D batteries (or LR20) into the battery compartment on the bottom of the iM7BLK. Make sure the batteries are installed as illustrated in the battery compartment (batteries not included). With your iPod seated into the iM7BLK docking station, turn on your iPod. Turn on the iM7BLK by pushing the power button located on the top of the unit. [. . . ] Universal power supply isn't connected to a wall outlet and / or the power supply connector is not plugged into the power supply jack on the back of the iM7BLK. surge protector (if used) isn't powered on. Plug the universal power supply into a wall outlet and plug the power supply connector into the power supply jack. If the universal power supply cord is plugged into a surge protector, make sure the surge protector is switched on. [. . . ]