User manual ALTEC LANSING 1712A SIGNAL PROCESSING

[. . . ] : Altec Lansing will, at its option, repair or replace any product that proves to be defective in material or workmanship. If your product is no longer being manufactured, or is out of stock, at its option, Altec Lansing may replace your product with a similar or better Altec Lansing product. How To Get Warranty Service: To get a covered product repaired or replaced, you must contact Altec Lansing during the warranty period by email (csupport@alteclansing. You must include in your email, your name, address, email address, telephone number, date of purchase and a complete description of the problem you are experiencing. [. . . ] Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. For service, refer to qualified service personnel, return to the dealer, or call the Altec Lansing service line for assistance. For products which incorporate batteries, please refer to local regulations for proper battery disposal. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. : This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Please note that in the European Union, you as a consumer might have other legal rights under national legislation of European Union Member States governing the sale of Altec Lansing's goods. Those rights are not affected by this guarantee. The above limited warranties and remedies are sole warranties and remedies available to purchaser, if, and to the extent, valid and enforceable under the applicable law. The answers to most setup and performance questions can be found in the Troubleshooting guide. You can also consult the FAQs in the customer support section of our Web site at www. nOTE: The Auto Shut-down (Standby) feature is active during batteryonly operation. If the AC wall adapter is used, the inMotion iM11 will remain on as long as the power switch is in the "On" position. Position the inMotion iM11 on a level surface, preferably close to you (within three feet). 5 mm stereo cable into the auxiliary input jack (AUX) located on the back of the inMotion iM11 system, and the other end to the headphone or line out jack on your alternate audio device. Set the volume on the inMotion iM11 at minimum level and adjust upward to a comfortable listening level. Use one of the following two options to power your inMotion iM11: AC (Wall outlet) Power Insert the barrel connector from the power supply into the DC connector on the rear of the inMotion iM11. After this connection is made, insert the power supply into a wall outlet. Move the slider to the right to increase the volume or to the left to decrease the volume. The power supply cord isn't connected to a wall outlet and/or the power supply connector is not plugged into the power supply jack on the back of the inMotion iM11. Insert the barrel connector from the power supply into the DC connector on the back of the inMotion iM11. After this connection is made, insert the power supply into a wall outlet. [. . . ] Set the volume on the inMotion iM11 at minimum level and adjust upward to a comfortable listening level. There is a crackling sound coming from speakers. The iPod is not correctly seated into the docking station. If using an alternate audio source, the audio source is not properly connected to the inMotion iM11 or there is a problem with the alternate audio source. [. . . ]