User manual ALTEC LANSING PT7031

[. . . ] The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Caution: To prevent the risk of electric shock, do not remove cover (or back). To prevent electric shock do not use this (polarized) plug with an extension cord, receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure. : Altec Lansing warrants that its products shall be free from defects in materials or workmanship, with the exceptions stated below. [. . . ] Avoid placing the PT7031 on or near surfaces that may vibrate. The PT7031 can be placed on a suitable level surface or mounted on the wall using the supplied wall mounting bracket. Use to toggle between On and Standby modes. Be sure to leave adequate ventilation space ­ at least 2 inches (50mm) above the PT7031 · We do not recommend installing this unit so that it is directly on the floor. Be sure to secure it where it will not fall and where it is out of the reach of children. Do not install this unit directly above a cathode-ray tube (CRT) TV as stray magnetic fields may distort the TV. If you are mounting the PT7031 on the wall please follow these steps: 1. Determine a suitable wall location for mounting the wireless speaker within reach of the unit's AC cord. Being careful to avoid any items (wires, pipes, etc. ) hidden inside the wall secure the metal mounting bracket using appropriate fasteners for the application. If you are unsure which type of fasteners to use or are unable to determine if there are items within the wall that could be damaged please consult a licensed contractor. Place the speaker on the mounting bracket by aligning the two buttonholes on the rear of the speaker with the posts on the mounting bracket. Check to make sure the wall mount bracket and speaker are securely fixed in place. Use to select virtual or stereo mode of system depending on the sound modes available from your audio source. Caution: The wall-mounting bracket should be installed only by qualified personnel. The mounting plate can be installed on many different types of walls. When installed, the mounting plate must support at least 100 lbs. The installer must be sure that the installing surface can support the 100 lb. The qualified installer must also determine and use the proper hardware to obtain the weight requirements for the wall. You can mount your TV on a commercially-available stand and place the PT7031 under your TV. Ensure that the stand being used can support the weight of the TV, the PT7031 and any other items it will be required to support. Note: Consult the instructions supplied with the stand for details on how to install the stand and how to mount the PT7031 and the TV on the stand. [. . . ] If you do not press any buttons after 10 seconds, SETUP MODE exits automatically. If you cannot find a code number from the Preprogrammed Remote Control Codes section of this manual that matches your equipment, the PT7031 remote can search its database for a suitable control code from the codes programmed into the remote. the PT7031 remote control will find the best possible component code for any audio source. To search for codes follow these steps: · Turn the device (TV, SAT/CAB, DVD, AUX, etc) that you wish to locate the remote control code for to the on position. [. . . ]