User manual AMERICAN AUDIO TTD-2500

[. . . ] · Before turning the power on, make sure once again all the connections and power voltage settings are correct. Always turn off the power when connecting or disconnecting. · Read this manual carefully before using the unit. Be sure to store the manual in a safe place for future reference. Warranty & Service The TTB-2500 has a 2 year limited warranty. [. . . ] (g) Rotate the counterweight counterclockwise until the scale shows the value corresponding to the pressure of the used stylus. The stylus pressure of the installed pick-up system is 2g. Should you use a separate pick-up system, please follow the manufacturer's instruments. Set the anti-skating control knob to the same value as the stylus pressure. Install the dust cover to the main unit. Placement · · · Do not place the unit in a location where it will be exposed to direct sunlight or near a heating appliance. Do not place the unit in a location where there is high humidity or a lot of dust. Cartridge may pick up slight sound pressure or vibrations of the speakers coming along the floor or though the air resulting in howling. Find a location which is very stable and vibration free. · The legs have functions for adjusting the height of the unit itself. Adjust the legs to stabilize the main body horizontally. Connect the power cord to the auxiliary power outlet on the rear panel of your amplifier or receiver or to a household AC outlet. Connect the unit output terminals to the the PHONO jack of your American DJ Mixer or receiver. Output terminals Mixer (Receiver) L (White) (18) ----------------------------> L Channel R (Red) (19) -----------------------------> R Channel GND (Spade) (21) ---------------------> Ground NOTE: Be sure to connect the ground terminals firmly to the Mixer or receiver. If this connection is not made or is loose, a power source "HUM" will result. TTB-2500 User Instructions page 3 User Instructions Operation 1. Push the power button (4) to turn on the power, the speed indicator (8) and the strobe-illuminator will light up. When playing a 45-rpm record with a large center hole, place the 45-rpm adapter (1) on the center spindle. Remove the stylus protector, release the arm clamp. Set the cueing lever to the up position. Press the Start/Stop button (5), the turntable platter will start to rotate. Move the tonearm (13) over the desired groove. Set the cueing lever to the down position, the tonearm will descend slowly onto the record and begin playing. [. . . ] Activated the "Fader Start" on the mixing console and the turntable automatically begins Start/Stop. Future American DJ mixers will be equipped with the "Fader Start" function. (1/4" connection) Beat Indicator (22) · The Beat output sends a mono pulse signal and may be used with a separate beat analyzer. (RCA connection) Maintenance · · · · Clean the stylus periodically with a soft brush to prevent the accumulation of dust. [. . . ]