User manual AMERICAN AUDIO WM-700LAV

[. . . ] 700 Channel Selectable Wireless Microphone or Lavalier WM-700HH or WM-700LAV User Guide Rev. 90040 (323) 582-2650 Fax (323) 582-2610 web: www. AmericanAudio. us WM-700TM ELECTRICAL SAFETY PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). THERE ARE NO USER SERVICEABLE PARTS INSIDE REFER SERVICE TO YOUR AUTHORIZED AMERICAN AUDIO® SERVICE TECHNICIAN. [. . . ] "MANUAL" mode: When the LCD display starts flashing, please press this button to move the number forward. "SCAN" mode: When the LCD display starts flashing, please press this button to scan in forward direction. "PRESET" mode: Press this button to change the preset group. Set Button: Use the Set button to search for your desired channel after you have selected your desired mode. Press for 2 seconds, until "MUTE" is displayed and the LCD display is flashing. Then press either the UP or DOWN buttons to change the channel. Stop pressing the button and the LCD display will flash five times and then lock the setting. volume Knob - Controls the volume of the receiver output. dC Out - Use this supplied cable to connect the receiver and the microphone. It takes around 10 hours to charge. ©American Audio® - www. americanaudio. com - WM-700TM Instruction Manual Page 5 6. Antennas - Receives RF signals from the transmitter. WM-700TM RECEIvER CONTROLS ANd FUNCTIONS CONT. 7. 12v dC Input - Connect the included power supply to this input, or any other 12v power adapter. Squelch Adjustment - The squelch adjusts the output level to prevent external noise. If you set the squelch to high you will reduce the range of the system. Set the squelch to a minimum before turning the receiver on. Mic/Line Switch - This switch lets you select your output source. If your connected to the line input on a mixer or amplifier set the switch to "Line". If your connected to a Mic input on a mixer or amplifier set the switch to "Mic". Unbalanced 1/4" Output - This unbalanced output can be used to connect the receiver to the line-level input of a mixer or amplifier. Balanced XLR Output - This balanced XLR output can be used to connect the receiver to balanced input of mixer or amplifier. WM-700TM RECEIvER MOdES Manual Mode: In manual mode you can set your desired channel manually. Select manual mode by pressing and holding either the UP or DOWN buttons until MANUAL is highlighted in the LCD. The LCD will start to flash and "MUTE" will appear in the LCD. [. . . ] Make sure the battery is inserted properly (+/- battery terminals must match transmitter termi nals). Move transmitter closer to the receiver. Make sure the receiver volume is not turned all the way down. Check the cable connection between receiver and amplifier or mixer. [. . . ]