User manual AMERICAN AUDIO XDM-343

[. . . ] Leave the device switched off until it has reached room temperature. Never put any liquids on the mixer or close to it. Should any liquid enter the device, disconnect from main power immediately. Have the device be checked by a qualified service technician before operating again. [. . . ] The XDM-343 also features two more 1/4 inch (6. 3mm) Mic jacks (27, 28) on the rear panel. You can adjust the microphone volume using the CHANNEL faders. Make sure that the respective PHONO / LINE / MIC switch is set to MIC. · You can connect 2 record players using the PHONO 1 jacks (18) and PHONO 2 jacks (19) on the rear panel. You can only control the record player signal after you switched the PHONO / LINE / MIC switches (5) to PHONO. The signal is then controlled via the CH-1 and CH-2 faders (6). If you wish to connect a third record player, switch the LINE 3 / PHONO 3 SELECTOR (29) on the rear panel to PHONO 3. You can only control the record player signal after you switched the PHONO 3-LINE 3 / LINE 4 / MIC 3 switch (5) to PHONO 3. The signal is then controlled via the CHANNEL 3 fader (6). · Connect your tape recorder, tuner, sound effects, CD player, cassette deck or any other line signals to the AMP OUTjacks (18, 19 & 20) on the rear panel. You can only control the line signals after switching the PHONO/LINE/MIC switches (5) to LINE. The signal is then controlled via the CH-1, CH-2 and CH-3 faders (6). © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-343 User Instructions page 2 Functions 10 4 3 2 1 11 5 12 13 14 6 7 8 15 16 17 9 (1) POWER SWITCH (2)MASTER LEVEL / PFL DISPLAY - The upper display shows the level of the left and right master output. The lower display shows the level of the channel currently being cued (PFL LED on). (3) GAIN CONTROL - Used to set the level of the input signal. (4) BASS/MIDDLE/TREBLE CONTROL - Used to increase or decrease the LOW's, MIDs, and HIs of the input signal. (5) PHONO / LINE I MIC SWITCH - Used to select the input to be sent to the individual channel. Channel 1 and 2 can be switched phono/line/mic. Channel 3 can either be switched line/line/mic or phono/line/mic. (6) CHANNEL FADER - Used to adjust the input level of each channel. (7) PFL/CUE BUTTONS - Use the PFL/CUE button to adjust the input level of each channel. (8) BEAT INDICATOR CHANNEL I / CHANNEL 2 - The LED lights up at every bass beat of the respective source. [. . . ] This helps to reduce humming and pop noises. (27) MIC I JACK - Connect your microphone with 1/4 inch (6. 3mm) jack plug here. The signals can be controlled via CHANNEL 1, if the PHONO / LINE / MIC switch (5) is set to MIC 1. © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-343 User Instructions page 4 (28) MIC 2 JACK - Connect your microphone with 1/4 inch (6. 3mm) jack plug here. [. . . ]