User manual AMOD AGL3080

[. . . ] AMOD GPS Photo Tracker AGL3080 We Add More Fun to Photo Sharing! © Copyright AMOD Technology Co. , Ltd. 8F, 46, Lane 10, Jihu Road, Neihu Taipei, Taiwan, 114, R. E-mail: sales@amod. com. tw AGL3080 GPS Photo Tracker User Manual V2. 0 Table of Content TA BLE O F C O NTE NT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 OV E R VI EW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] (c) User's each change of the logging mode at the setup mode is recorded by the system. If thesystem is cut off power unexpectedly, the last setting value before power off is recorded. Therefore, the system power on at GPS mode, it will run at the last setting value. Install/Replace Battery The device requires three standard AAA size batteries to operate. NiH rechargeable batteries or alkaline batteries are recommended. package. ] To install or replace battery, please: 1. Flip the device so that the bottom side is up. Find the latch of the battery compartment cover and slide it sideways to release the cover. [Please note that batteries are not part of the accessories included in the 3. Pull the cover out to open the battery compartment. The batteries can be easily inserted, but please ensure the correct polarity. WARNING: Wrong polarity will cause permanent damage to the device. A Note on Battery and AGL3080's Operating Time Batteries have wide range of capacity (in mAh) and voltage level (even though they are specified as 1. 5 V). These factors will cause variation of AGL3080's operating time. Please check to ensure the quality of batteries is meeting its specifications. We recommend using 1. 5 V and 900 mAh AAA batteries. NiH type battery is recommended when using AGL3080 in a low temperature environment. Using the Accompanying AMOD Photo Tracker Software to Tag Your Photo s You can install the AMOD Photo Tracker Software by clicking the Setup button (the setup file) in the included CD-ROM. You can specify which directory to install the Photo Tracker Software. An icon (short-cut) will also be created at the Desktop for easy access to the software tool. [First, you need to download and store the pictures from your DSC to your PC. This is necessary because the local computer time is used as the standard time to derive the offset (the difference) between the DSC time (stored in the photo image file) and the standard time. Please make sure your local time zone and time are both correct and accurate. You can conduct the Time Sync operation by clicking the Time Sync icon to bring up the following window and check the "Enable Time Sync. " button to begin the operation. The Input DSC Time field is for you to enter the time that will be used to sync with the DSC time. There are two steps involved ­ adjust time zone and adjust actual time. [. . . ] This may happen when inside a building or tunnel, or due to weather condition or the GPS signal is blocked by objects such as buildings, trees, metal shields, etc. When this happens, the GPS Status LED will stay on and no GPS data will be logged. Please check and adjust the orientation and position of the AGL3080 to ensure no blockage and facing open sky. When the AGL3080 can receive GPS signal, the GPS Status LED will resume blinking. [. . . ]