User manual AMX AXB-TCTCR TELEVISION CONTROLLERRECEIVER

[. . . ] instruction manual AXB-TC and AXB-TCR Television Controllers AXlink Bus Controllers AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: · · · Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, and MX Series products are warranted for a period of one (1) year. AMX Lighting products are guaranteed to switch on and off any load that is properly connected to our lighting products, as long as the AMX Lighting products are under warranty. AMX Corporation does guarantee the control of dimmable loads that are properly connected to our lighting products. [. . . ] 11 IR signal attenuation POT location Use a Phillips-head screwdriver and flat-blade tool (non-conducting) to adjust the POT screw. Static electricity can damage electronic circuitry. Discharge any static electricity from your body by touching a grounded metal object before adjusting the POT. AXB-TC and AXB-TCR Television Controllers 11 Installation and Wiring 1. Remove the two Phillips-head screws on the bottom of the television controller enclosure. Pull the two enclosure halves apart and set the bottom portion of the enclosure on a flat surface. Locate the POT screw on the circuit card and turn it counterclockwise with a flat-blade tool until it stops. Turn the POT screw clockwise one-eighth turn to increase signal saturation. Then, send an IR control signal to the television. If the television performs correctly, go to step 5. If not, repeat this step until the television performs the correct operation. Send an IR control signal to the television for all programmed operations. If an operation fails, go back to step 4. Reattach the enclosure and refasten the two screws. Replacing the Lithium Battery There is a lithium battery (FIG. 12), with a life of approximately five years, in the television controller that protects stored presets if there is a power loss. The battery is not used when DC power is supplied to the television controller. You should write down the replacement date on a sticker or label by adding 5 years to the date of installation, and attach it to the bottom of the television controller. Battery (CR2025 type) socket FIG. 12 Lithium battery and socket All control commands in television controller memory are lost when the lithium battery is replaced. Contact your AMX dealer before you replace the lithium battery to verify that they have a current copy of the IRLIB program file for your television controller. This will prevent any inadvertent loss of data or service outage. Static electricity can damage electronic circuitry. Before removing the battery from the enclosure, discharge any static electricity from your body by touching a grounded metal object. Use a flat-blade tool (non-conducting) that can be slipped under the lithium battery to pry it up and out of the socket. Discharge the static electricity from your body. Unplug all cables from the television controller. Remove the two Phillips-head screws on the bottom of the television controller enclosure. Pull the two enclosure halves apart and set the bottom portion of the enclosure on a flat surface. [. . . ] If any devices still indicated the old version, repeat preceding steps 3 through 5 until all panels indicate the correct firmware version. Upon completion of the upgrade, press F10 to exit SOFTROM. Firmware Device Number Version Number Type Number Loading status and device number FIG. 14 Loading status bar Firmware can be downloaded to multiple device numbers automatically. If multiple devices are selected, the bottom half of the loading bar will indicate the percentage complete for the selected devices. [. . . ]