User manual AMX AXF-S AXCESS SERVER CARDFRAME (WITH AXC-S CARD)

[. . . ] Reference Guide AXC-S CardFrame Server Card Overview The AXC-S CardFrame Server Card (FIG. 1) is a processor card that manages communication among control cards in a CardFrame. [. . . ] Apply power to the CardFrame and verify a "one-blink" pattern on the AXlink LED (CR1). Refer to the CR1 Specifications for more information on blink patterns. S1 DIP switch Handling grip FIG. 1 AXC-S Server Card (side view) Specifications AXC-S Specifications Power Processor Mounting Program Chip LED Indicators 30 mA @ 12 VDC Motorola MC68HC705 Inserts into the CS slot in an Axcess CardFrame Onboard OTP (One Time Programmable) chip · · · · CR1 (AXlink) indicates transmission of data Full On - indicates no communication with master Full Off - indicates no power being received by unit One blink/second - indicates normal operation AXLink Connector · Front connector used for AXlink communication. · Also used for daisy-chaining several CardFrames together. Setting the AXlink Device DIP switch (S5) The eight-position Device DIP switch (S1), shown in FIG. 2 assigns the value to the CardFrame using the AXC-S card. The Device DIP switch example is set to 1, the factory default setting. 2 DIP switch (S1) The AXlink device number range is 1-255. The Device DIP switch positions determines their values, based on the following table. Device DIP Switch (S1) Settings and Values Position Value 1 1 2 2 3 4 4 8 5 16 6 32 7 64 8 128 The dip switch sets the first address of the card frame with the other 15 slots following in order. For example: if set to one, the card frame addresses are set from 1 to 16. [. . . ] AMX reserves the right to alter specifications without notice at any time. 3000 research drive, richardson, TX 75082 USA · 469. 624. 8000 · 800. 222. 0193 · fax 469. 624. 7153 · technical support 800. 932. 6993 [. . . ]