User manual AOC V22T

[. . . ] USER'S MANUAL Thank you very much for choosing the LCD TV. We suggest that you spend several minutes to read carefully this manual before you install and turn on the TV. Note: Since this product is being continuously improved, changes may be made to this manual without notice. *In case of discrepancy between the graphics attached herein and the ones shown on the physical screen, the latter shall prevail. USER'S MANUAL Table Of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When the TV set is not used for a long period of time, it is preferable to pull the power cord out of the power socket. Turn On/Off the LCD 1. Turn on the LCD Switch on the AC power supply on the back of the TV set and press the Power key on the remote controller or press the Power key on the panel. The indicator will turn blue and the LCD TV will enter normal operating mode several seconds later. 2. Turn off the LCD Press the Power key on the remote controller or press the Power key on the panel to turn off the LCD. 3. Indicator status . Normal, the TV indicator turns blue. . Standby, the TV indicator turns orange. . Off, the blue TV indicator goes off after flashing three times. Searching Press the "TV" key on the remote controller to switch to the TV signal source, then press the "Menu" key on the remote controller or the "Menu" key on the right side of the panel to enter the main menu page. Press the Searching key or enter the searching page to search channels automatically. Suggestion: select Auto for the color system and DK for the sound system. To select automatic searching: It will search for all TV programs and save them to the memory. Normally TV programs can be watched after the above steps are completed. In case of any abnormality or to further understand the unit, read the following contents. About the control panel and interface PANNEL CONTROL KNOBS Input: Menu: CH/ : Vol / : Press this button to change input source. Press this button to display or exit the OSD menu. When the OSD menu appears, press these two buttons to select the item you want to execute; when no OSD menu appears, use to change channels in TV mode. When the OSD menu appears, press these two buttons to select or adjust the selected item; when no OSD menu appears, use to adjust the volume. SOURCE INTERFACE Several signal source devices can be connected to your TV set. The following diagram shows how to connect them. Tips: If you want to hang the TV set on the wall, all connecting wires must be inserted into the interfaces of the TV set first. Whenever a peripheral device is connected to the TV set, ensure that the TV set is turned off. When connecting a peripheral device, connect the cable to the connecting terminal that is the same color as the cable color. SOURCE INTERFACE Antenna Input: Insert the antenna connector into the antenna jack of the TV. The interface is a 75 coaxial cable input. Video/S-terminal input Connect the video signal source or S-terminal cable to a device such as a DVD, laser disc player, video recorder or camera. Audio input: Connect the audio signal source (computer, DVD, laser disc player, video recorder or camera, etc. ) to the audio input port. In case of any barriers between the main unit and the remote controller, the remote controller may not work. Note: To ensure safe operation, please do the following: 1. Do not use a new battery together with an old one. [. . . ] It may be the Radio Station's problem. Adjust the contrast and brightness settings. *Check that the TV is not muted; press the button on the remote control. Check whether the correct TV system is selected. [. . . ]