User manual AOPEN 0204D-NVGF4MXNU

[. . . ] Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/television technician for help. [. . . ] Ground yourself to an anti-static mat or other grounded source. Position the card directly over the AGP slot and insert one end of the card down into the slot. Be sure the metal contacts on the bottom of the host adapter are securely seated in the slot. Connect your analog monitor's 15-pin VGA connector to the card and fasten the retaining screws (if any). Connect other cables and devices if available. Now you are ready to install the software drivers and utilities. For Systems with existing VGA card Change your display driver to Standard VGA. Shut down your computer and unplug all electrical cards. Replace the existing VGA card with the new graphics card. Restart your computer and install the new display driver. Windows ME / 98 / 95 Installation Windows ME / 98 / 95 Installation Procedures Caution: l l l Before installing the display driver, make sure your Windows ME/98/95 is installed in VGA mode and works fine. To take advantage of all the AGP features, please use Windows 95 OSR2. 1 ( or later version ), or Windows ME / 98. Otherwise, you can use OSR2. 0 and install USBSUPP. EXE from Microsoft to upgrade to OSR2. 1 The AGP driver is required for non-Intel chipset, please use correct AGP driver to install for different chipset. Setup Standard VGA Mode ( For First Time Installation ) 1. Start Windows ME/98/95 Add New Hardware Wizard dialog box will appear and detect as Standard PCI Graphic Adapter (VGA). Click Next to begin setup the VGA driver. If the Windows ask you for your Windows ME/98/95 CD, insert the CD, or change the path to \Windows\System directory. Windows will prompt you to restart your windows, Click Yes to reboot. You may begin to setup VGA driver. 3. 4. 5. Windows ME / 98 / 95 Installation Setup Standard VGA Mode ( For Upgrading ) 1. Click mouse right button on the desktop and select Properties from the popup menu, or double click on the Display icon from the Control Panel folder. Select Setting->Advanced ( or select Setting->Advanced Properties for Windows 95 ), then select Adapter page, and click change button. Windows ME / 98 / 95 Installation 3. When Update Device Drivers Wizard dialog box appears on screen, select Display a list of all drivers, so you can select the driver you want. Select Standard display types from the manufacturers and select Standard PCI Display Adapter( VGA ) from the Models then click OK button. 4. 5. After complete installing Standard VGA Driver. [. . . ] l Please install the Windows NT 4. 0 Service Pack 3 ( or above version ) before installing the video driver. Otherwise, the system may hang up and won't be able to start up. l D: present the drive containing the Installation CD disk. After System start in VGA mode, fellow Setup GF2Ti Series Driver Step to Setup display driver. Windows XP / 2000 / NT 4 Installation Setup Display Card Driver ( Auto setup ) Please refer to Chapter 2. 3 for Auto-Setup installation procedures. [. . . ]