User manual AOPEN AOI-908

[. . . ] Wireless Broadband Router For xDSL/Cable Connections User Guide October 2002 Wireless Broadband Router User Guide Wireless Broadband Router User Guide October 2002 Copyright Information in this document is subject to change without notice and does not represent a commitment on the part. The material contained herein is supplied without representation or warranty of any kind. Therefore assumes no responsibility and shall have no liability of any kind arising from the supply or use of this document or the material contained herein. No part of this document may be copied or re-used without prior written consent Wireless Broadband Router User Guide 2 Warranty Broadband Router Products are provided with a limited one-year Warranty. [. . . ] This setting requires you to enter a user name to identify you and a password for authentication. This type of connection is called a Point-to-Point over Ethernet (PPPoE) connection and is normally used over XDSL modems. User name: The username of your ISP account. Password: The password of your ISP account. Idle Time: After this period of inactivity, the router will disconnect from the ISP. The default value of the idle timeout is 5 minutes. You can change the idle timeout value to anything between 0 to 60 minutes. A value of zero means there is no idle timeout. 3. Dynamic IP via DHCP: This type of connection is normally used over Cable modems. It is the default connection type to the ISP. It uses a method called the Dynamic Host Control Protocol (DHCP). In order to identify your account, Your ISP may require you to enter a Host Name and/or MAC Address. Host Name: The Host Name is optional, but may be required by some ISPs. Wireless Broadband Router User Guide 13 4. Dynamic IP via PPTP: This type of connection is called the Point-to-Point Tunneling Protocol over Ethernet (PPTPoE) and provides a secure connection over the Internet and is normally used when connecting to a remote LAN through the Internet. In a manner similar to PPPoE, your ISP requires you to enter a user name and password in order to identify you. You also need to enter an IP address that is "tunneled" through the Internet. PPTP Local IP address: The "tunneled" IP address provided by your ISP. PPTP Local Net mask: the IP Network mask associated with the above address. PPTP Remote IP address: the IP address from your ISP User name: the user name of your ISP account. Password: the password of your ISP account. Important Note: If you used WinPoET/ RASPPPoE (PPPoE Dial-up Software) or a Windows PPTP · application in your computer, you must remove or disable this software in order to operate properly. The router replaces your PPPoE or PPTP software when communicating with your ISP. If you don't know your connection type, please contact your Internet Service Pro· vider. MAC Address: Some ISPs may identify you by a specific MAC address. A MAC address is a physical identifier of an Ethernet port, in this case the EWAN port that is connected to the Cable modem. [. . . ] When the router sees a Wireless Broadband Router User Guide 28 privately addressed PC attempting to make connection with a Trigger Port using the TCP, UDP, or BOTH protocols, it will use the settings configured on this page to allow connections from the Internet to multiple ports on the private PC. This screen specifies the public ports to be opened for these applications. Select an Application: From the drop-down list, select one of the standard applications listed, in which case, the following information will be filled out for you, or select CUSTOM to enter the following information yourself. Trigger Port: Specify the port number for the application. Trigger Type: Select the protocol type as TCP, UDP or BOTH. [. . . ]