User manual AOPEN CRW9624

[. . . ] AOpen CRW9420 / CRW9624 User's Manual 2 Copyright Copyright 1998 by this company. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company. Disclaimer This company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is". Should the programs prove defective following their purchase, the buyer (and not this company, its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. [. . . ] 4 Device Configuration Jumper The Device Configuration Jumper will be set to Master as factory setting. 3. Installation The Connectors are located as shown below. The function of each parts are also described below. 11 Installation Conditions: Mounting direction Installation Angle Horizontal / Vertical (Eject Button must be upside. ) 15 degree or less Fig. 5 Installation Conditions Compatibility: Because Compact Disc do not perform error correction and defect alternation at writing, written data may have error. We recommend to verify the written disc if you are writing important data. 12 4. ! Dismantling the drive to attempt repairs or for other reasons is dangerous because the laser may radiate outside the unit. Install the drive in accordance with the specifications. Be careful to avoid locations likely to cause vibration or shock. Avoid locations where there is high humidity, much dust, or poor ventilation. Avoid locations in direct sunlight, with severe changes in humidity, or places where there are extremely high or low temperatures. Don' t use the drive near radio or television receivers. It may interfere with their reception. 5. ! ! Don't suddenly move the drive from a cold place to a warm one, or suddenly raise the room temperature. Condensation may occur, causing abnormal operation. Make sure to remove the disc before moving the drive. The disc may be damaged, causing data loss. Be careful to prevent foreign objects such as liquids or metal from entering the drive. Should by chance a foreign object enter the drive, please consult the dealer where the drive was purchased. Don' t use benzene or thinner to clean dirt from the drive. Don't allow chemicals such as insecticides to contact the drive. ! wipe the drive, or moisten a cloth with neutral detergent diluted with water and use it to clean particularly dirty areas. [. . . ] Push a pin * straight into the emergency eject hole located to the right of the eject button to eject the Disc Tray. * Diameter: 1. 5 to 1. 9 mm Length: 80 to 100 mm 16 SPECIFICATIONS 1. Functionality 1. 1 Recording Data should be recorded on the optical disc in response to host computer command. Drive receives necessary information such as logical block address, number of block and data to be recorded from the host computer. [. . . ]