User manual AOPEN DRW8800APP0403A

[. . . ] · Do not stick any paper or labels on the disk. · Discard warped or cracked disks because they may damage the drive unit. · Do not use specially shaped disks such as heart shape or polygon. Note: In accordance with Part 15 of FCC, it has been confirmed that this equipment has passed the test and meets the restrictions on Grade-B digital model. The purpose of design restriction is to provide reasonable protection for home appliance against harmful interference. [. . . ] Do not spray any liquid on this product. Condensation: When the unit is moved from a cold area into a warm environment, moisture can form around the operational part and damage the performance. To move the unit to a warmer location, place the product in the new environment for 1 to 2 hours before turning it on. Maintenance: Do not attempt to repair this product, which could put you at risk of contact with a hazardous voltage or other danger after opening or removing the cover. Instead, you should ask a qualified person to perform all maintenance works (please refer to the provided maintenance backup card) · Remove the dust on the disk with soft cloth or cotton ball by rubbing from inside toward outside instead of circling the disk. · Do not use disk cleaner or anti-static agent to avoid hurting the disk with the solvent. When putting aside, keep all disks in the storage case. Before use, be sure to check if dirt or dust is left on the disk (especially the recording face). Features · Writing Speed DVD-R, at 8X-Zone CLV, 6X-CLV, 4X-CLV, 2X-CLV, 1X-CLV. DVD+R, at 8X-Zone CLV, 6X-CLV, 4X-CLV, 2. 4X-CLV. CD-R, at 24X-Zone CLV, 20X-Zone CLV, 16X-CLV, 8X-CLV, 4X-CLV. CD-RW, at 24X-Zone CLV, 20X-Zone CLV, 16X-CLV, 10X-CLV, 4X-CLV. Reading Speed: DVD-ROM (single layer), at CAV 12X DVD-ROM (double layer), at CAV 8X DVD-R and DVD-RW, at CAV 8X DVD-RAM, at CLV 2X DVD+R and DVD+RW, at CAV 8X CD-ROM and CD-R, at CAV40X / CD-RW: CAV 32X. · Buffer Memory Capacity: 2 Mbyte (writing, reading) · IDE Data Transmission Mode PIO Mode 4, Multi Word DMA Mode 2 , Ultra DMA Mode2 · Backup Video CD · 5. 25 " half-height built-in type. · LCD Split Server · Available in horizontal/vertical direction. · Low-vibration assembly using DRA System. Disk Format (reading/writing) · DVD single layer/double layer /120mm disk/80mm disk. · DVD-R (Ver. 2. 0) · DVD-RW(Ver. 1. 0 & Ver. 1. 1 & Ver. 1. 2 ) · DVD+R(Ver. 1. 0 & Ver. 1. 1 & Ver. 1. 2) · DVD+RW(Ver. 1. 1 & Ver. 1. 2) · CD-ROM Mode 1 · CD-ROM XA Mode 2(Form 1, Form 2) · Photo CDSingle/Multiple Session · CD-DA · CD-Extra (CD PLUS) · CD-R · CD-RW, Ultra-speed CD-RW Note: Special application programs supporting the above-said format must be written. Interface Front View 1 Force Eject Hole If the tray fails to eject upon pressing the Eject button, insert the eject pin into the hole and then push out the tray from within. In normal operation, use the Eject button to eject the tray. At this time, confirm the drive power has been disconnected and then wait for over one minute until the disk stops turning before inserting the pin in the eject hole. 2 Data Processing Indicator The indicator below shows the operation situation: Reading Indicator on Writing Indicator on 3 Eject Push Button Push this button to eject/load the disk. 4 Disk Tray Push Eject button and open the tray and then load the CD or DVD, with label facing upward. Press the Eject button or push the front part of the loading tray. [. . . ] · When using the Sound Card, be sure to connect the audio output port and the sound card with the audio cable. Confirm the power required for this product provided by the connected PC. Do not use any other power source besides the PC power. Pin #1 Audio Cable IDE Interface Power Specification [Installation] This drive is available for vertical and horizontal application. [Disk Size] · 12cm (4. 72") / 8cm (3. 15")* * 8cm (3. 15") cannot be used in vertical application. [Data Transmission Speed] Data Readingcontinuous type DVD Max. [. . . ]