User manual AOPEN DVD9532

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual AOPEN DVD9532. We hope that this AOPEN DVD9532 user guide will be useful to you.

Lastmanuals help download the user guide AOPEN DVD9532.

Download

Manual abstract: user guide AOPEN DVD9532

Detailed instructions for use are in the User's Guide.

 [. . . ] Copyright
Copyright © 1998 by this company. No part of this publication may be reproduced,  transmitted,  transcribed,  stored in a retrieval system,  or translated into any language or computer language,  in any form or by any means,  electronic,  mechanical,  magnetic,  optical,  chemical,  manual or otherwise,  without the prior written permission of this company. 

Disclaimer
This company makes no representations or warranties,  either expressed or implied,  with respect to the contents hereof and specifically disclaims any warranties,  merchantability or fitness for any particular purpose.  [. . . ] INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER. CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM
THAT TO WHICH THE RECEIVER IS CONNECTED. 

CONSULT THE DEALER OR AN EXPERIENCED RADIO TV TECHNICIAN FOR HELP. 

Notice: This changes or modifications not expressly approved by this party responsible for compliance could void the user's authority to operate the equipment. 

2

Specification
Transfer Rate DVD-ROM data: maximum 6760KB/s. (5X CAV mode speed) CD-ROM data: maximum 4800KB/s. (32x CAV mode speed) Data Buffer 512 KB. Drive Interface Type E-IDE Disc Data Capacity DVD: Single Layer 4. 7GB Dual Layer 8. 5GB CD: Mode 1 656MB Mode 2 748MB Data Type DVD: DVD-5,  DVD-9,  DVD-10,  DVD-R and DVD-RAM. (Data Format) CD: CD-Audio,  CD-ROM (mode 1 and mode 2),  CD-ROM XA (mode 2,  form 1 and form 2),  CD-I (mode 2,  form 1 and form 2),  CD-I Ready,  CD-I Bridge,  CD-WO,  CD-RW,  Photo CD,  Video CD,  Enhanced Music CD 44. 1 KHz Audio Sampling Frequency Audio Quantization 16 bit linear

Installing the DVD-ROM Drive
First,  turn off the system power,  then please follow below steps to install the DVDROM drive. Adjust the Master/Slave jumpers on the rear side of the DVD-ROM drive as necessary. (The factory default of the slave mode normally should not be changed. ) 2. Screw the DVD-ROM drive unit into a free 5. 25-inch drive bay. Plug connectors to the sockets on the rear side of DVD-ROM drive. Digital Audio Master/Slave Jumper Audio Connector IDE Connector Power Connector

3

Master/Slave Jumper

Cable Select Master

Slave

NOTE: Normally,  the red edge of the IDE cable corresponds to pin 1 of the IDE interface on the DVD-ROM drive. NOTE: The DVD-ROM drive supports Ultra DMA/33 mode to improve IDE data transfer rate.  [. . . ] Gently poke the hole with a sharp needle or a clip. When the disc tray opens,  pull out the tray and remove the disc from the DVD-ROM drive. 

4 [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AOPEN DVD9532

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual AOPEN DVD9532 will begin.