User manual AOPEN EHB-5232U

[. . . ] No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of our company. All brand and product names are trademarks and/or registered trademarks of their respective holders. Disclaimer We make no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is". Should the programs prove defective following their purchase, the buyer (and not our company. , its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. [. . . ] This is particularly important when you write files to CD from HDD. Defragment of HDD reallocates all the files so that these relevant files are placed in the nearby clusters. This saves time and risks when Easy CD Creator is trying to search for the files you want to record on CD. 4. 2. Installing Software For information on installing procedures and how to use the authoring software, please refer to the manual that came with it. If you want to use another type of authoring software not bundled with this COMBO drive, please refer to each manual on how to install and operate. Please note that some authoring software or version of authoring software does not support this COMBO drive. -- E-11 -- Specification 5. Firmware Upgrade The COMBO drive uses Flash type firmware, a small piece of software that can be overwritten and updated. To ensure more reliable operations and enhanced performance of the drive, updates to the firmware will be made available. You can download and upgrade the latest version via our Web site regularly. Confirming the firmware version The Windows 98SE users can confirm the firmware version on the COMBO drive property with Device Manager. For Windows 2000 users, the firmware version will not be displayed. Use your writing software to check it. -- E-12 -- Specification English 5. 2. Troubleshooting Write problems Symptom No drive recognition Possible Causes Solutions Bad connection between Ensure that USB cable is not damaged. Using other writing software Use the writing software provided with this which not supports your Combo drive. When using other software, USB2. 0 Combo drive. ensure your Combo drive is supported by contacting the software supplier. Using other writing software Use the writing software provided with this which not supports your Combo drive. When using other software, USB2. 0 Combo drive. ensure your Combo drive is supported by contacting the software supplier. Check if the power cord is securely connected to the connector. USB cable isn't connected Ensure the cable of USB connectors are not properly damaged. Install more than one CD Remove other writing software. Just keep one writing software set of software on your hard disk. [. . . ] If the disc you just loaded is a blank CD disc, try it later after copying some information to the CD. -- E-18 -- Specification English Q: Unable to see a second session reading from a CD-ROM drive. Eject the CD and re-load it. Select the My Computer icon in Windows Explorer and press F5. Make sure if your CD-ROM drive reads CD-RW discs. CD-RW discs can only be used in CD-RW or newer MultiRead CD-ROM. [. . . ]