User manual AOPEN MX3W-OV

[. . . ] Chapter 1 Overview MX3W is a new generation Socket 370 based system board that utilizes Intel 810 AGPset on Micro ATX PCI/ISA platform. This AGPset is designed for Celeron PPGA CPU, and supports new architectures such as high speed AGP graphic port, PC100 SDRAM, AMR slot, Ultra DMA 33/66, Bus master IDE, PCI 2. 2 and USB port. It has two Dual in-line Memory Module (DIMM) slots that allow to install PC100 SDRAMs and expand up to a maximum of 512MB. Also, MX3W uses 4M bit Flash ROM BIOS to reserve for future new functions. [. . . ] Floppy interface supports 3. 5 inches drives with 720KB, 1. 44MB or 2. 88MB format or 5. 25 inches drives with 360KB, 1. 2MB format Dual-channel IDE interface support maximum 4 IDE hard disks or CDROM, mode 4 , bus master hard disk drives and Ultra DMA 33/66 mode hard drives are also supported. Two USB ports supported by USB bracket, the BIOS also supports USB driver to simulate legacy keyboard. Mini-Din PS/2 keyboard connector onboard. Lithium (CR-2032) battery is an option, no battery is needed if power cord is plugged. AWARD Plug-and-Play, 4M bit Flash ROM BIOS. Form Factor Board Size CPU System Memory Chipset Onboard AGP Audio CODEC Expansion Slots Serial Port Parallel Port Floppy Interface IDE Interface USB Interface PS/2 Mouse Keyboard RTC and Battery BIOS 1-4 Overview 1. 2 ACPI Suspend to Hard Drive For a detailed installation procedure please refer to the following procedure to enable ACPI Suspend to Hard Drive on the AOpen MX3W motherboard. First please check if your system meets the following requirements, then follow the procedure step by step. AOZVHDD. EXE 1. 30b or later (http://www. aopen. com. tw/tech/mbdrv/ default. htm#Suspend to Hard Disk Drivers). Execute "Setup. exe /p j" to install Windows 98. After Windows 98's installation is completed, go to Control Panel --> Power Management. Set "Power Schemes -> System Standby" to "Never". Click on "Hibernate" and select "Enable Hibernate Support" then "Apply". Click on the "Advanced" tab, you'll see "Hibernate" on "Power Buttons". Note that this option will only be seen after step b mentioned above has been completed, otherwise only "Standby" and "Shutdown" will be shown. Select "Hibernate" and "Apply". If you assign the whole disk to your Win 98 system (FAT 16 or FAT 32), please run "aozvhdd /c /file" in DOS mode. Please remember sufficient free space has to be reserved in the disk, e. g. if you have 64 MB DRAM and 16 MB VGA card installed, the system needs at least 80 MB free space. The utility will locate the space automatically. If you assign an individual partition for Win 98, please run "aozvhdd /c /partition". Of course, the system needs to provide unformatted an empty partition. You've already implemented ACPI with Suspend-to-Harddisk. Click "Start -> Shut Down -> Standby" then the screen will go off immediately. [. . . ] Go to BIOS Setup à Integrated Peripherals à Power On Function. For details, please refer to "Chapter 3 AWAED BIOS" 3. Successfully boot your system to Windows or DOS. Setup your application, put into Windows 95 Start Up. [. . . ]