Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual AOPEN P5TC-TS. We hope that this AOPEN P5TC-TS user guide will be useful to you.
Lastmanuals help download the user guide AOPEN P5TC-TS.
Detailed instructions for use are in the User's Guide.
[. . . ] The simple way to identify power failure is to check the CPU fan and the power supply fan. If these are not working, then the power is down. Turn off the power and remove all add-on cards, connectors and SIMMs from your mainboard. Then reinstall the VGA card and two SIMMs. [. . . ] Disable the power management and USB functions. Some add-on cards, drivers or applications may not be compatible with these functions. Disable the external cache (2nd level cache) in chapter 3 "Advanced CMOS Setup" (AMI) or "BIOS Features Setup" (AWARD). If the system works fine, your cache module or onboard PBSRAM may be malfunction. Enter BIOS and set the HDD "Block" and "32-bit" mode parameters to OFF. Refer to Chapter 3 "Standard CMOS Setup" (AMI) or "Integrated Peripherals" (AWARD) for details. Also, if possible set HDD PIO mode 2 or 3 to a slower transfer speed. Turn off the power and remove all add-on cards, connectors and SIMMs from your mainboard. Then reinstall the VGA card, two SIMMs and connect only one hard disk to the end-most connector of the IDE cable. The IDE cable length must not exceed 46cm (18inches), refer to section 2. 3 "Connectors". If the system functions properly, reinstall the add-on cards one by one. This will help you find out which card or device is causing the problem. Be sure to connect the 2nd IDE device (HDD/CD-ROM) to the primary channel slave mode.
4. 5.
6.
7.
B-2
Troubleshooting
8. If your CPU bus frequency is 66MHz, set the CPU external/bus frequency to 60MHz, but leave the CPU core/bus frequency ratio unchanged. Normally, CPU with 66MHz bus frequency works properly at slower speed, e. g. , 60MHz. This will help you identify if the CPU is remarked or if the mainboard or add-on card is unstable at 66MHz.
Keyboard, Mouse, Printer or Floppy is not working properly.
1. Make sure that pin 1 of the cable is connected to pin1 of the connector. Pin 1 of the flat cable is indicated by a red-colored wire. Refer to section 2. 3 "Connectors". If possible, use another system to test the peripherals and cables. If possible, use another peripheral to double check if the mainboard or the cable is defective.
2. [. . . ] Refer to Chapter 3 "Advanced CMOS Setup" section. Some applications has trouble at higher system speed. Visit our WWW home page, (address http://www. aopen. com. tw), check the FAQ area (frequently asked question) and download the latest BIOS, try again with the latest BIOS. Important: If problem still exist after you have done all the corrective actions listed in this appendix, fill out the attached problem report form. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE AOPEN P5TC-TS
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual AOPEN P5TC-TS will begin.
