User manual AOPEN SV520

[. . . ] :SV520-OL-E0206A A Open 1 SV520 Copyright 2002 AOpen Incorporated All Rights Reserved. AOpen SV520 User's Guide © Online Manual Changes may be made periodically to the information in this publication without obligation to notify any person of such revision or changes. Such changes will be incorporated in new editions of this manual or supplementary documents and publications. This company makes no representations or warranties either expressed or implied, with respect to the contents hereof and specifically disclaims the implied warranties of merchantability or fitness for a particular purpose. No part of this publication may be reproduced. , stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopy, recording, or otherwise, without the prior written permission of AOpen Incorporated. All brand and product names mentioned in this manual are trademarks and/or registered trademarks of their respective companies. 2 A Open SV520 1. [. . . ] See "Removing drive bay covers" on page 28. 5. Secure the casing with two screws. A Open 30 SV520 Online Manual 6. 7. Connect the power cable and signal cables to the storage devices. Reinstall the side panel. 31 A Open SV520 To remove a 3. 5" storage device: 1. 6. Online Manual Open the front panel door and remove the side panels. See "Opening the housing panels" on page 25 for more information. Use a Phillips screwdriver to remove the screws located on the right side of the plastic casing. Again, use a Phillips screwdriver to remove the screws located underneath the storage device. Detach the 3. 5" storage device from the plastic casing. Use the drive bay cover to cover the drive bay. Insert it into the empty drive bay and secure it with one screw. Reinstall the side panel. A Open 32 SV520 1. 4. 3 Installing and Removing a 5. 25" Device Drive 5. 25-inch device into the drive bay. 3. Online Manual You may install a CD-ROM, digital-audio tape (DAT), hard disk, diskette drive or any other Open the front panel door and remove the side panels. See "Opening the housing panels" on page 25 for more information. Attach the driver rail to one side of the plastic casing and secure it with two screws. Insert the 5. 25" storage drive into the bay. If the drive bay has a cover, remove the cover first. See "Removing drive bay covers" on page 28. 33 A Open SV520 4. Secure the storage drive with two screws. Online Manual 5. 6. Connect the power cable and signal cables to the external devices. Reinstall the side panels. A Open 34 SV520 To remove a 5. 25" storage device: 1. Disconnect the power and signal cables. Online Manual Open the front panel door and remove the side panels. See "Opening the housing panels" on Use a Phillips screwdriver to remove the screws located on the right side of the storage device. [. . . ] However, the cooling fans in front are hot-swappable. When the front cooling fans becomes defective, you can simple take it out and put a new one in even when the system is operating. Make sure that there are three cooling fans (two in front and one at rear) distributed in the chassis to ensure proper system operation. Also, remember to shutdown the system when changing a defective rear cooling fan. A Open 50 SV520 1. 8. 1 Hot-Swap Fan Base Board Online Manual 51 A Open SV520 Connector or Jumper JP1 JP2 Fan1 to 4 Description Power connector Signal cable (4-pin) Hot-plug fan connector Online Manual 1. 8. 2 Replacing Housing Fans To change a rear housing fan: 1. Shutdown the system Open the front panel door and remove the side panels. [. . . ]