User manual APC SMART-UPS C 1000VA TOUR

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] You may select Always On or use a specific schedule that you have defined. To create and edit schedules, please refer to “Schedules” on page 55. D-Link SMART-UPS C 1000VA TOUR User Manual 35 Section 3 - Configuration VIRTUAL SERVERS LIST ID: This identifies the rule. Service Ports Enter the public port(s) you want to open. Server IP: Port: Enter the IP address and port of the computer on your local network that you want to forward the Service Ports to. Enable: Tick the checkbox to enable the specified rule. Schedule Rule #: Specify the schedule rule number. To create schedules, please refer to “Schedules” on page 55. D-Link SMART-UPS C 1000VA TOUR User Manual 36 Section 3 - Configuration Application Rules Some applications require multiple connections, such as Internet gaming, video conferencing, and Internet telephony among others. These applications may have difficulty working through NAT (Network Address Translation). Application Rules allow some of these applications to work with the SMART-UPS C 1000VA TOUR by opening ports after detecting traffic being sent through a trigger port. After modifying any settings, click Save Settings to save your changes. Popular Applications: Select from a list of popular applications. MAC FILTERING SETTINGS MAC Address Control: Tick this box to enable MAC Filtering. Connection Control: Wireless and wired clients with C selected can connect to this device and allow/deny connections from unspecified MAC addresses. Association Control: Wireless clients with A selected can associate to the wireless LAN and allow/deny connections from unspecified MAC addresses. MAC FILTERING RULES ID: This identifies the rule. MAC Address: Specify the MAC Address of the computer to be filtered. IP Address: Specify the last section of the IP address. Wake On LAN: Click Trigger to configure Wake On LAN. C: If this box is ticked, the rule will follow the connection control setting specified in MAC filtering settings specified above. If this box is ticked, the rule will follow the association control A: setting specified in MAC filtering settings specified above. D-Link SMART-UPS C 1000VA TOUR User Manual 39 Section 3 - Configuration URL Filter URL Filter allows you to set up a list of websites that will be blocked from users on your network. After modifying any settings, click Save Settings to save your changes. URL Filtering: Select this box to enable URL Filtering. [. . . ] Try to place the router/access point as high as possible in the room, so the signal gets dispersed throughout your home. If you have a two-story home, you may need a repeater to boost the signal to extend the range. Eliminate Interference Place home appliances such as cordless telephones, microwaves, and televisions as far away as possible from the router/access point. This would significantly reduce any interference that the appliances might cause since they operate on same frequency. [. . . ]