User manual APC SMART-UPS RT 3000VA

[. . . ] Therefore these units do not meet the requirements for use in direct patient care. 1 BATTERY SAFETY This equipment contains potentially hazardous voltages that may cause personal injury if handled incorrectly. This equipment must be installed and serviced only by qualified electrical service personnel. This equipment contains potentially hazardous voltages. The unit contains no user serviceable parts. [. . . ] Each foot needs one expansion piece for each external battery pack you are using. Additional expansion pieces are shipped with the external battery packs. Snap all center expansion pieces together, and then snap the brackets back onto the ends of the expansion piece(s) to complete the foot. Repeat with the other foot. REMOVING THE BATTERY TRAYS FROM THE BATTERY PACK The battery pack is heavy. To lighten it, remove the battery trays. Battery trays in your external battery pack are installed and removed just like the battery tray found in your UPS. The battery trays are accessible from the front of the battery pack (shown at left). This procedure requires a Phillips screwdriver. Notice that two battery tray compartments are visible. The External Battery Pack is shipped with the bezel removed, but the top decorative panel attached. If your external battery pack has been in operation, you will need to remove the top decorative panel and front bezel before gaining access to the battery compartments. Remove them using instructions found in your UPS User’s Manual. Continue following instructions in the UPS User’s Manual section Remove and Reinstall Battery Pack to remove the battery doors, disconnect batteries (if the battery pack has been in use; the batteries are shipped disconnected) and remove the battery trays. POSITIONING THE BATTERY PACK AND UPS If more than 2 external battery packs are to be connected to the UPS, you will need more than one person to properly support and rotate the attached units during the installation, even after removal of all battery trays. 5 1. Position the UPS on the battery pack(s). Reattach the expanded feet according to the instructions in your UPS User’s Manual. Screw the feet firmly into both the UPS and each battery pack. Screw the rear bracket tie(s) in place between the external battery pack and the UPS, and between each external battery pack if you are daisy chaining more than one battery pack to your UPS. Carefully rotate the whole attached unit upright onto the feet. Reinstall the battery trays into the UPS and battery packs. Reattach the front bezels and top cover panels. Instructions for these steps can be found in your UPS User’s Manual. [. . . ] Pack the unit in its original packaging. If the original packing is not available, ask APC Customer Service about obtaining a new set. Pack properly to avoid damage in transit. Never use Styrofoam beads for packaging. [. . . ]