User manual APPLE 12 MINI

[. . . ] This manual includes technical instructions for replacing genuine Apple parts in iPhone and is intended for individual technicians with the knowledge, experience, and tools required to repair electronic devices. If you're not comfortable performing the repairs as instructed in this manual, don't proceed. Always use the latest version of this document available at support. Failure to follow the repair instructions or to use genuine Apple parts or proper tools may cause fire or other safety issues and lead to personal injury or death. [. . . ] Ethanol or isopropyl alcohol may damage the display and affect image quality. Inspect the internal display clips for damage before reassembly. Ensure that the internal display clips are at a 90-degree angle and aren't bent or damaged. If the internal display clips are damaged, you may need to replace the display. If you're installing a replacement display, peel the protective liner from the top and underside Inspect the enclosure for loose or extra screws and small parts, which can damage the battery and cause safety issues. Place the enclosure in the repair tray with the Lightning connector facing the cutout. Ensure that the top edge of the TrueDepth camera is under the lip of the enclosure. If the TrueDepth camera is positioned incorrectly, use the black stick to move it away from the grounding clip. Then insert the top edge of the TrueDepth camera under the lip of the enclosure. Align the replacement display adhesive over the enclosure with the top holes over the TrueDepth camera assembly and the bottom tab on the left. Ensure that you've removed all adhesive residue from the display and the enclosure before you apply the replacement display adhesive. The replacement display adhesive has a top release liner, a middle release liner, and a bottom release liner. Grasp the tab from the bottom release liner. Then slowly pull the bottom release liner (1) out from under the adhesive (2) while pressing the adhesive onto the enclosure. important Don't remove the top release liner yet. Note: The replacement display adhesive for your model may look different from the illustration, but the steps are the same. Place the display adhesive press plate on top of the enclosure with the icon in the top right corner as shown. Position the repair tray with the iPhone in the display press. Pull down the lever until the display press locks. Wait until the timer on the display press beeps. Pull down the lever (1) and pull out the release knob (2). Remove the repair tray from the display press and remove the press plate. [. . . ] Read Battery Safety and follow workspace and battery handling guidelines before you begin. Remove the following part before you begin: · Place the enclosure in the repair tray with the Lightning connector facing the cutout. Use a torque driver and the JCIS bit to remove the four crosshead screws from the speaker. Use the black stick to tilt up the speaker. [. . . ]