User manual APPLE IMAC G5 17 INCH MEMORY REPLACEMENT INSTRUCTIONS

[. . . ] iMac G5 computers work with memory modules (DIMMs) that meet all of these criteria: PC3200, 2. 5V, unbuffered, 8-byte, nonparity, 184-pin, 400Mhz DDR SDRAM. The maximum amount of RAM you can install is 2 GB. You can use RAM module sizes of 256 MB, 512 MB and 1 GB, in either slot. [. . . ] Note: Turn the screws counterclockwise until they stop turning. 6. Holding the back cover by the metal foot, tilt the cover up. Set the back cover aside. 4 - iMac G5 Memory Removing the Memory 1. Touch the metal surface (as shown below) on the inside of the computer to discharge any static electricity. Warning: Always discharge static electricity before you touch any parts or install any components inside the computer. To avoid generating static electricity, do not walk around the room until you have finished installing the part and closed the computer. iMac G5 Memory - 5 2. Locate the memory module(s) in the bottom right corner. 3. Rotate the computer counterclockwise so the memory is in the position shown below. To release the memory from its slot, push down on the two side latches. Then pull the memory module out of the slot. Repeat this step if you have a second memory module. Important: Return the memory to Apple in the packaging provided. 6 - iMac G5 Memory Installing the Replacement Memory 1. Remove the replacement memory module from its packaging. Replace the memory module(s) by lining up the notch on the module with the notch on the slot. 3. Press firmly on the memory module until it clicks into place. Use your thumb and index finger to push the module into the slot. iMac G5 Memory - 7 Closing the Computer 1. [. . . ] Turn on the computer. 10 - iMac G5 Memory Apple Computer, Inc. Copyright Law and International Treaties, and no part of this document may be reproduced in any form without written permission from Apple. Apple is not responsible for typographical, printing, or inadvertent errors. [. . . ]