User manual APPLE IPOD

[. . . ] You can remove the dock adapter with your fingernail by using this slot. Browse for a song on iPod, then press Play (') and enjoy!Use the buttons on your iPod Hi-Fi or on the included Apple Remote to increase or decrease the volume. Read on to learn about connecting iPod to your iPod Hi-Fi, connecting other audio devices, adjusting the sound, using the Apple Remote, and more. [. . . ] m Press and hold the Menu button on the remote. The status light blinks green, and the iPod pauses. to switch back to the iPod , press and hold the Menu button again. You can also remove your iPod to switch to a device connected to the audio input port. To play audio from your computer using your iPod Hi-Fi: m You can connect an AirPort Express Base Station to your iPod Hi-Fi and stream audio wirelessly from a computer in another room. M In most cases, you can also connect a computer directly to your iPod Hi-Fi using an audio cable. If you have a computer with optical digital audio, such as a Mac Pro or a MacBook Pro, you can connect it using an optical digital cable for better quality sound. With some newer models of iPod, you can also adjust the volume using the iPod Click Wheel. If you connect another audio device that has volume controls to the audio input port, such as a stereo receiver, you can also change the volume using the other device. Experiment to see which volume level sounds best when using the device with your iPod Hi-Fi. To change equalizer settings: m If you're playing music through an iPod, change the settings on the iPod. To set your iPod Hi-Fi to work only with the included remote: 1 Connect your iPod Hi-Fi to an electrical outlet. Note: If your iPod Hi-Fi has batteries, you don't need to connect it to an outlet. 2 Make sure other products that are compatible with the remote are not in range, and hold the remote close to your iPod Hi-Fi (about 3 to 4 inches away). 3 Press and hold the Menu and Next/Fast-forward (`) buttons on the remote simultaneously for about six seconds. The status light blinks green several times. Your iPod Hi-Fi now works only with the paired remote. To reset your iPod Hi-Fi to work with all Apple Remotes: m Follow steps 1 and 2 above. Then press and hold the Menu and Previous/Rewind (]) buttons on the remote simultaneously for about six seconds. The status light blinks green several times. Your iPod Hi-Fi now works with all Apple Remotes. When not in use, your iPod Hi-Fi enters a low-power standby mode to save battery life. [. . . ] Â Make sure you can play music through your iPod Hi-Fi using the iPod controls. The remote battery may need to be replaced (see page 21). Â If you have more than one Apple Remote and you have paired your iPod Hi-Fi with one of them, make sure you're using the right remote. For instructions on setting your iPod Hi-Fi to work with any Apple Remote, see page 22. [. . . ]