User manual APPLE LED CINEMA DISPLAY 27 INCH GETTING STARTED GUIDE

[. . . ] Follow these steps to set up your Apple LED Cinema Display: 1 Remove the protective film from the display and cables. 2 Insert the power cord into the display, and then insert the AC plug into a grounded power outlet. 3 Plug the MagSafe connector into the MagSafe power port on your MacBook to charge the battery and provide power to your computer. 4 Connect the USB cable to your computer to use the display's built-in iSight camera, microphone, speaker system, and USB ports. [. . . ] To secure your display, attach a locking cable to the security slot. Using a VESA Mounting Solution with Your Display You can attach your display to an alternative mounting solution, using the VESA Mount Adapter Kit available from the Apple Online Store at www. Use the kit to attach your display to any available VESA-compatible mounting solution. Simply follow the instructions included with the kit. Before you lift or reposition your display, you may need to disconnect the cables and power cord. Use correct lifting techniques when positioning the display. To clean the screen on your display: 1 Disconnect the power cord. 2 Use the cloth that came with your display, or another soft, dry cloth, to wipe dust from the screen. WARNING: Don't clean the screen with a cleaner containing alcohol or acetone. Use a cleaner intended for use with a screen or display. never spray cleaner directly on the screen. It may drip inside the display and cause damage. Don't operate your display in areas with significant amounts of airborne dust, or smoke from cigarettes, cigars, ashtrays, stoves, or fireplaces, or near an ultrasonic humidifier using unfiltered tap water. Tiny airborne particles produced by smoking, cooking, burning, or using an ultrasonic humidifier with unfiltered water may, in rare instances, enter the ventilation openings of your display and, under certain conditions, result in a slight haze on the inside surface of the glass panel that covers the display. Follow these safety guidelines for using your display: Â The only way to completely disconnect power is to unplug the power cord. Â Disconnect power immediately if the power cord is frayed or damaged, if you spill Something on the display, or if the display falls or is damaged in some other way. WARNING: Use only the power cord that came with your display. The power cord has a three-wire grounding plug (a plug that has a third grounding pin) that fits only a grounded AC outlet. If you are unable to insert the plug into an outlet because the outlet is not grounded, contact a licensed electrician to replace the outlet with a properly grounded outlet. WARNING: Your display is a high-voltage component and should not be opened for any reason, even when it's unplugged. If your display needs service, see "Learning More, Service, and Support" on page 16. Here are some guidelines for adjusting your display to reduce glare and to accommodate your physical size and shape. [. . . ] This equipment complies with the Canadian ICES-003 Class B specifications. This display is not intended for use in the operation of nuclear facilities, aircraft navigation or communications systems, or air traffic control machines, or for any other uses where the failure of the computer system could lead to death, personal injury or severe environmental damage. As an ENERGY STAR® partner, Apple has determined that this product meets the ENERGY STAR® requirements for energy efficiency. the ENERGY STAR® program is a partnership with electronic equipment manufacturers to promote energy-efficient products. [. . . ]