User manual APPLE LOGIC STUDIO INSTRUMENTS AND EFFECTS

[. . . ] Logic Studio Instruments and Effects Apple Inc. © 2007 Apple Inc. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Apple. Your rights to the software are governed by the accompanying software licence agreement. The Apple logo is a trademark of Apple Inc. , registered in the U. S. [. . . ] Note: On keys C# to A#, the percussion only works in Percussion Mode Always (see "Percussion" on page 332). Disabling MIDI Preset Switching You can disable the switching of presets with MIDI notes 24 to 35, thus avoiding any problems that may arise from transpositions. To do so, set the MIDI to Presetkey parameter to "off. " Chapter 22 EVB3 333 Cancel Key, Registering While Playing The lowest preset key (C) is the cancel key. If you depress it, all drawbars are moved to their minimum setting. The other 11 keys, from C# to B, recall registrations. You can edit recalled presets immediately. The preset memorizes these alterations instantaneously, with no further action required. This means that if you recall a new preset, the former preset memorizes the drawbar settings at the time the new preset was recalled. If you hold the cancel key (C) on your master keyboard with the small finger of your left hand, and sustain a chord with your right hand, you can trigger the chord with different registrations, by clicking the preset keys with the other fingers of your left hand. This results in an organ-specific gate-type effect, which wouldn't be possible with the right hand alone. Morphing You can switch between the presets of the Upper manual with any MIDI controller-- such as the modulation wheel. Choose the desired MIDI controller with the MIDI CC parameter. The step or linear Mode parameter options determine whether an abrupt switch, or a seamless morph (cross-fade), occurs between presets. Note: Switching the registers with this morphing function is only available for the Upper manual. Range After deciding on a controller to use for switching or morphing the Upper manual registers, you can determine the number of preset keys that are affected. The morphing (or switching) always begins with the top preset key, the B. If Range = A#, you will switch or morph between two presets. If Range = G#, you will switch or morph between four presets (B, A#, A, and G). Save To In Linear Mode (morphing instead of switching), the seamless crossfades result in a variety of new drawbar registrations you might want to save. Before saving, you may wish to alter some drawbar positions manually. Click the words Save To, and select the destination preset key. You do not need to do anything else, in order to save the setting to another preset key. Note: As soon as you morph, the Morph text turns orange, indicating changes--in other words, you're performing a morph. The morphing result(s) can be further modified with the drawbars, but are lost if you don't save. [. . . ] If you cut an audio file at a zero crossing there will be no click at the cut point. zoom An action that enlarges (zooms in on) or shrinks (zooms out from) the display in a window. zoom level The amount that window contents are magnified. Zooming in to a high level allows you to make more precise edits. [. . . ]