User manual APPLE POWERBOOK FIREWIRE AIRPORT CARD REPLACEMENT INSTRUCTIONS

[. . . ] PowerBook (FireWire) AirPort Card Replacement Instructions Be sure to follow the instructions in this sheet carefully. Failure to follow these instructions could result in damage to your equipment and may void your warranty. [. . . ] Your new PowerBook comes with the keyboard unlocked, so unless you or someone else locked the keyboard, you can skip this step. ® 2 - PowerBook (FireWire) AirPort Card 4 Release the keyboard by pulling down on the keyboard release tabs (located to the left of the F1 and F9 keys) until the top portion of the keyboard pops up. 5 Lift the top portion of the PowerBook keyboard up slightly near the top row of keys and pull it back far enough to release the small tabs that hold the bottom of the keyboard in place. PowerBook (FireWire) AirPort Card - 3 6 Flip the keyboard over and lay it on the palm rests. 7 If your AirPort Card came with the AirPort adapter, remove the metal clip and pull the AirPort Card from the adapter. (The adapter and metal clip are not used with your PowerBook. ) AirPort Card AirPort Adapter Metal Clip 8 Touch a metal surface inside the computer to discharge any static electricity. Important: To avoid electrostatic discharge, always ground yourself by touching a metal surface before you touch any parts or install any components inside the computer. To avoid static electricity building back up in your body, do not walk around the room until you have completed your installation and closed the computer. 4 - PowerBook (FireWire) AirPort Card 9 With a Phillips screwdriver, remove the screws that secure the internal heat shield. Screws Heat Shield . 10 Lift up the internal heat shield. 11 Position the AirPort Card with the AirPort ID numbers and bar code facing up and connect the AirPort Card to the end of the antenna cable. Make sure that the connector on the end of the antenna cable is straight before inserting it into the card. AirPort Card Connector AirPort Card AirPort Antenna Cable PowerBook (FireWire) AirPort Card - 5 12 Slide the card into the connector located just above the PC Card slot. Make sure to slide the card all the way in until you feel that the card is securely attached to the connector. Note: When inserting the AirPort Card, you may need to tuck the edge of the card under the opening in the plastic case (where the top of the keyboard attaches). This helps align the card with the connector and prevents the back end of the card from sticking up after it has been inserted. AirPort Card AirPort Card Connector AirPort Card 13 Insert the internal heat shield and replace the screws. When replacing the internal heat shield, make sure it does not cover the plastic tabs for the hard disk and AirPort Card. [. . . ] 1 Infinite Loop Cupertino, CA 95014-2084 408-996-1010 http://www. apple. com Apple, the Apple logo, FireWire, and PowerBook are trademarks of Apple Computer, Inc. , registered in the U. S. AirPort is a trademark of Apple Computer, Inc. 8 - PowerBook (FireWire) AirPort Card [. . . ]