User manual APPLE STUDIO DISPLAY 17 ADC MONITOR STAND REPLACEMENT INSTRUCTIONS

[. . . ] · Place the monitor upside down on a thick cloth. · Install the replacement monitor stand. · Place the monitor upright, connect the display cable, and restart the computer. [. . . ] Place the monitor upside down on the cloth so the screen is away from you and the monitor stand is in front of you. 3. Slide the monitor stand toward the display cable. Monitor Stand Cloth Display Cable 2 - Apple Studio Display 17 (ADC) Monitor Stand 4. In the center of the monitor stand, locate the two identical round openings in the retaining clip. Retaining Clip Round Openings 5. Using two jeweler's flat-blade screwdrivers, place one in each of the round openings and gently pry up the retaining clip until it is out of the monitor stand. Warning: If any tools or parts drop into the monitor, do not turn on the monitor. Never turn on your monitor unless all of its internal and external parts are in place and it is closed. Operating the monitor when it is open or missing parts can damage your monitor or cause injury. Apple Studio Display 17 (ADC) Monitor Stand - 3 6. Rotate the stand clockwise (1/4 turn) so it is positioned as shown. 7. Peer into the center of the monitor stand and swivel it somewhat until you can see the locking tabs line up with the slots in the base. Locking Tabs 4 - Apple Studio Display 17 (ADC) Monitor Stand 8. With the tabs aligned, gently pull the stand toward you. Then tilt the stand up off the base. Positioning the Plastic Rings After you remove the monitor stand, two plastic rings should remain on the base. These rings are fitted in a special orientation so the replacement stand will fit properly. However, if the rings are dislodged, replace them as follows: 1. Place the white plastic ring on the base so that you can still read the words "Serial Number" when the ring is slid all the way down. Turn the ring over if the words are not visible White Ring Correctly Installed Apple Studio Display 17 (ADC) Monitor Stand - 5 2. Place the clear plastic ring over the white ring so that the white ring fits inside the clear ring. Check that the rings are properly aligned. [. . . ] Use of the "keyboard" Apple logo (Option-Shift-K) for commercial purposes without the prior written consent of Apple may constitute trademark infringement and unfair competition in violation of federal and state laws. Every effort has been made to ensure that the information in this document is accurate. Apple is not responsible for printing or clerical errors. [. . . ]