User manual APPLIED ENERGY AWC

[. . . ] What the installer will need · If using flexible cable, suitable glands incorporating cable clamps must be fitted to the knockouts in the Controller Box. Not where ambient temperatures are likely to exceed 500 · If installed in a kitchen the Controller must not be mounted immediately above a cooker or eye level grill. ⷠWhen intended for use in possible chemical corrosive atmospheres, consult our Technical Service Department (outside the UK contact your local Xpelair distributor) · If installed in a shower room or bathroom the controller and isolating switch must be situated so that they cannot be touched by persons making use of the bath or shower. Pointing away from walls or other obstructions, to ensure adequate ventilation. [. . . ] Installing the Controller These installation instructions are for the installation of the controller when used in combination with Xpelair supplied fans. The controller must be installed to fixed wiring. Working with the Fan If wiring to an existing installation isolate mains supply and remove applicable fuses prior to any electrical procedure. Disconnect the mains connections from the fan's terminal socket or from the terminal block. Route the four core cable from the controller position to each fan. Route the three core cable from controller position to the isolator position. Detach the Fascia from the Mounting Frame by removing the screw covers and two screws (Refer to Fig. Detach mounting Frame from the Wall Box by removing the two screws (Refer to Fig. Check that the electrical rating shown inside the controller matches the power supply. Disconnect the earth wire from the Wall Box. Mounting the Wall Box Eye protection must be worn during all drilling and chiselling operations. Check there are no buried Pipes or Cables in the wall or obstructions on the outside e. Fix the Wall Box and Plastic Surround to the wall, using the mounting holes provided. Make a hole in the wall big enough to take the Wall Box. Ensure that the flange of the mounting frame fits flush to the finished surface of the wall (Refer diagram F3. Mounting the Sensors Using the two clips supplied, mount the temperature sensors horizontally, without touching the walls or ceiling. ⷠMount the sensor with the 10m cable in the high level position. ⷠMount the sensor with the 1m cable in the low level position suitably protected. [. . . ] ⷠNever immerse the controller in water or other liquids. ⷠNever use solvents to clean the controller. ⷠApart from cleaning, no other maintenance is required. The controller is guaranteed against defects for 3 years from the date of purchase. [. . . ]